Delphi TA5311 Steering Tie Rod End - Outer

Delphi TA5311 Outer Tie Rod End

Delphi TA5311 is a standard replacement steering tie rod end built for outer steering linkage service on select Chevrolet and GMC applications. It combines OE-based dimensional and material analysis with pre-greased construction, a dust boot, and a coated steel housing for dependable steering response.

Key Features

• Part number TA5311 outer steering tie rod end
• Fits 1971-1972 Chevrolet Blazer, outer, rear wheel drive
• Fits 1971-1972 Chevrolet C10 Suburban, outer
• Fits 1971-1972 GMC G15/G1500 Van, outer
• Fits 1971-1972 GMC Jimmy, outer, rear wheel drive
• Pre-greased with grease fitting included for serviceability
• Dust boot included to help protect the joint from contamination
• Steel tie rod and steel housing with coated finish
• Straight, non-adjustable design with male threaded ends
• Mounting hardware included

Detailed Description

Delphi TA5311 is engineered as an OE-style steering tie rod end for the outer position on classic Chevrolet and GMC trucks and vans. It is built with a steel housing, steel tie rod, plastic bearing material, and a chloroprene rubber dust boot, then finished with a protective coating for everyday corrosion resistance. Delphi validates its steering components through extreme temperature exposure and extended salt-spray testing, supporting consistent fit and function in demanding road conditions. This part cross-references MOOG Chassis Products ES415RL for the same application.

Common Steering Issues It May Address

• Loose or wandering steering feel at the front end
• Clunking or play from worn outer steering linkage
• Uneven tire wear caused by steering component wear
• Steering response that feels delayed or imprecise
• Visible boot damage or grease loss at the tie rod end

Installation Notes and Tips

Verify outer position fitment before installation and confirm thread direction, thread diameter, and stud style against the original part. TA5311 uses clockwise thread direction on both ends and is not adjustable, so alignment should be checked after replacement. Inspect the steering linkage, related joints, and fasteners for wear before returning the vehicle to service.

Quality Assurance

Delphi applies OE-focused engineering and dimensional analysis to help match aftermarket steering parts to original equipment requirements. The component is tested for temperature extremes and salt-spray exposure to support durability in real-world use.