Delphi TA5316 Steering Tie Rod End

Delphi TA5316 Steering Tie Rod End

Delphi TA5316 is a standard replacement steering tie rod end built for direct-fit service on select Jeep applications. It uses a steel housing and steel tie rod construction with a coated black finish, pre-greased design, grease fitting, and dust boot for serviceable steering maintenance.

Compatible With Jeep CJ5, Jeep CJ7, Jeep Scrambler, and Jeep Wagoneer steering positions listed below, this Delphi tie rod end supports OE-style fitment for left outer, right outer, and pitman arm applications where specified. Delphi TA5316 is engineered using dimensional and material analysis to match OE and aftermarket requirements.

Key Features

• Part number: TA5316
• Steering tie rod end, straight type
• Steel housing and steel tie rod material
• Black coated finish
• Pre-greased with grease fitting included
• Dust boot included with chloroprene rubber material
• Mounting hardware included
• Non-adjustable design
• Standard replacement item grade
• Male threaded ends with threaded stud design

Detailed Description

Delphi TA5316 is built for steering linkage service where a direct replacement tie rod end is needed. The part measures 104.0 in length, 41.0 in width, and 79.8 in height, with a 0.688 tube diameter and a 16.0 cone outside diameter. It features a 0.5 end 1 thread diameter with 20 threads per inch and a 0.688 end 2 thread diameter with 18 threads per inch, plus a counterclockwise end 2 thread direction.

Delphi applies OE-focused testing and material analysis to its steering portfolio, including exposure to extreme temperatures and salt spray testing for corrosion resistance validation. This part cross-references MOOG Chassis Products ES62L for the same application. Use Delphi TA5316 when servicing Jeep CJ5, Jeep CJ7, Jeep Scrambler, or Jeep Wagoneer steering components that call for this fitment.

What It Helps Repair

• Steering play caused by worn tie rod end joints
• Loose or imprecise steering response
• Clunking or knocking from steering linkage wear
• Dust boot damage that exposes the joint to contamination
• Corrosion-related steering component deterioration

Installation Notes and Tips

Verify the steering position before ordering, since Delphi TA5316 is listed for left outer, right outer, and pitman arm positions depending on vehicle application. Confirm thread direction, thread diameter, and stud style against the removed part before installation. After replacement, inspect steering alignment and check all linkage points for wear.

• Fits 1976-1986 Jeep CJ7, Right Outer (Steering Arm To Steering Arm)
• Fits 1981-1985 Jeep Scrambler, Right Outer (Steering Arm To Steering Arm)
• Fits 1972-1983 Jeep CJ5, Right Outer (Steering Arm To Steering Arm)
• Fits 1972-1973 Jeep Wagoneer, At Pitman Arm, Four Wheel Drive
• Fits 1963-1971 Jeep CJ5, Left Outer
• Fits 1959-1962 Jeep CJ5, Left Outer, Four Wheel Drive

Quality Assurance

Delphi uses OE-based dimensional and material analysis for aftermarket steering parts and validates performance through temperature and salt-spray testing. That approach supports consistent fit and durability for Jeep steering service applications covered by this part number.