Delphi TA5341 Steering Tie Rod End - Inner

Delphi TA5341 Inner Tie Rod End

Delphi TA5341 is a standard replacement steering tie rod end built for front inner steering applications. It is engineered with OE-focused dimensional and material analysis to match the original part more closely, helping maintain steering feel and alignment integrity on select Hummer H3 and H3T models.

• Fits 2007-2010 Hummer H3, inner
• Fits 2009-2010 Hummer H3T, inner
• Fits 2006 Hummer H3, inner, 2nd design
• Straight, adjustable tie rod end for front inner steering use
• Steel housing and steel tie rod construction with coated finish
• Pre-greased design with mounting hardware included
• Male-to-male ends with 16.0 mm thread diameter and 1.5 thread pitch
• Cross-references MOOG Chassis Products EV800609 for the same application

Product Details

The Delphi TA5341 steering tie rod end is designed for OE-style replacement on the front inner steering linkage. It uses a steel housing, steel tie rod material, and a coated black finish for durability, while the pre-greased design supports straightforward service installation. This part is a standard replacement for vehicles that require an inner tie rod end with clockwise thread direction on both ends and 16.0 mm thread sizing.

For fitment-based searches, this part is a direct match for Delphi TA5341 inner tie rod end applications on 2007-2010 Hummer H3 and 2009-2010 Hummer H3T, plus the 2006 Hummer H3 2nd design inner position. If you are replacing worn steering linkage components on a Hummer H3 or Hummer H3T, confirm the application tab and steering configuration before ordering.

Common Steering Issues It Can Address

• Excessive steering play or looseness at the front inner linkage
• Clunking or knocking from worn steering components
• Uneven tire wear caused by steering linkage wear
• Steering wheel wander or reduced directional stability
• Failed inspection due to worn tie rod end condition

Installation Notes

Verify the vehicle’s steering configuration, thread direction, and inner position before installation. Because this is an adjustable steering component, a professional alignment is recommended after replacement. Inspect related steering parts, including outer tie rod ends and boots, for wear before completing the repair.

Quality Assurance

Delphi applies OE engineering standards to its aftermarket steering portfolio and validates parts through extreme temperature exposure and extended salt-spray testing. The TA5341 is built to support OE-level fit and material compatibility for the specified Hummer H3 and H3T applications.