Delphi TA5350 Steering Tie Rod End - Inner

Delphi TA5350 Inner Tie Rod End

Delphi TA5350 is a standard replacement inner steering tie rod end built for precise steering linkage service. It is compatible with Chevrolet Chevette, Pontiac Fiero, and Pontiac T1000 applications listed below, with OE-focused dimensional and material analysis to support proper fit and steering response.

• Inner steering tie rod end for steering linkage repair
• Adjustable straight design
• Steel housing and steel tie rod construction
• Pre-greased for initial service
• Coated black finish for added surface protection
• Male end 2 with 14.0 mm thread diameter and 1.5 thread pitch
• Mounting hardware included
• Compatible with Chevrolet Chevette inner steering applications
• Compatible with Pontiac Fiero inner steering applications
• Compatible with Pontiac T1000 inner steering applications

OE-Style Steering Fit

Delphi applies OE engineering experience to its aftermarket steering portfolio, and TA5350 reflects that approach with careful dimensional and material analysis for fitment consistency. The inner tie rod end uses a steel housing, steel tie rod material, and POM bearing material, with clockwise thread direction on both ends and an adjustable straight layout. This part number, TA5350, is listed for 1976-1987 Chevrolet Chevette inner, 1984-1987 Pontiac Fiero inner, and 1981-1987 Pontiac T1000 inner applications.

This part cross-references DNJ EV121 for the same application.

Common Repair Uses

• Restores steering linkage movement when the inner tie rod is worn
• Addresses steering play or looseness at the front end
• Helps correct uneven tire wear caused by steering component wear
• Supports accurate toe adjustment after steering service
• Replaces a damaged or corroded inner tie rod end

Installation Notes

Verify thread direction, thread diameter, and overall length before installation. TA5350 is pre-greased and does not include a grease fitting or dust boot, so inspect adjacent steering components and replace worn boots or related hardware as needed. After installation, perform a professional alignment to confirm steering geometry on Chevrolet Chevette, Pontiac Fiero, or Pontiac T1000 applications.

Quality Assurance

Delphi tests steering components across extreme temperature and corrosion conditions, including sub-zero and high-heat exposure plus extended salt-spray testing, to evaluate durability in demanding service. The brand also uses OE-level dimensional and material analysis to support aftermarket fit and performance consistency.