Delphi TA5368 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End for Acura NSX

Delphi TA5368 is a right outer steering tie rod end built for precise steering response and OE-style fitment. It is listed for 1995-2005 Acura NSX applications and is engineered with Delphi’s aftermarket steering expertise for direct replacement service.

• Fits 1995-2005 Acura NSX, right outer
• Part number: TA5368
• Standard replacement steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included for added joint protection
• Steel housing and steel tie rod construction
• Coated black finish
• Mounting hardware included
• Bent design with threaded stud

Built Around OE Dimensions

Delphi applies dimensional and material analysis to match OE requirements as closely as possible, helping the tie rod end align with the steering geometry used on the Acura NSX. TA5368 is a non-adjustable, right outer steering tie rod end with clockwise thread direction at both ends, a female end 2, and a 12.0 mm end 2 thread diameter. The pre-greased joint, plastic bearing material, and chloroprene rubber dust boot support smooth operation and help protect the internal components from contamination.

This part cross-references Dorman - Premium 172286 for the same application.

What This Part Helps Address

• Loose or vague steering feel at the front right corner
• Clunking or play from a worn outer tie rod joint
• Uneven steering response during lane changes or cornering
• Steering alignment issues caused by worn linkage components
• Boot damage that can expose the joint to dirt and moisture

Installation Notes

Install Delphi TA5368 on the right outer steering position only. Because this is a non-adjustable tie rod end, verify the steering linkage condition and complete a wheel alignment after installation. Confirm thread direction, thread diameter, and overall dimensions against the removed part before assembly on the Acura NSX.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That validation supports OE-level durability for Acura NSX steering service and helps ensure consistent replacement performance.