Delphi TA5373 Steering Tie Rod End - Left Outer

Delphi TA5373 Left Outer Tie Rod End

Delphi TA5373 is a steering tie rod end for the left outer position, built as a standard replacement for select Dodge W200, W300, W250, and W350 applications. It uses a straight, steel housing with a coated finish, pre-greased construction, and a dust boot to support consistent steering response in demanding road conditions.

Key Features

• Part number TA5373 for left outer steering service
• Fits select Dodge W200, W300, W250, and W350 models with 4500lb axle(s)
• Straight tie rod end design with steel housing and steel bearing material
• Pre-greased with grease fitting included for serviceability
• Dust boot included with chloroprene rubber construction
• Coated black finish for added corrosion resistance
• Threaded stud design with mounting hardware included

Detailed Description

Delphi applies OE-level dimensional and material analysis to its steering portfolio so the aftermarket part matches the original application as closely as possible. TA5373 is engineered for the left outer steering position and is listed as a standard replacement tie rod end for 1976-1980 Dodge W200 and W300, plus 1981-1993 Dodge W250 and W350, all with 4500lb axle(s). This part cross-references Dorman OE Solutions 534-269 for the same application. Delphi TA5373 is also cross-referenced to MOOG Chassis Products ES2010L for the same application.

What This Part Helps Address

• Loose or wandering steering feel at the left outer tie rod location
• Uneven tire wear caused by worn steering linkage components
• Clunking or play in the front steering connection
• Corrosion-related wear on exposed steering hardware
• Restoration of steering linkage geometry on Dodge W200, W300, W250, and W350 trucks

Installation Notes and Tips

Verify the vehicle’s axle configuration and steering position before ordering, since this part is specified for the left outer location on models with 4500lb axle(s). Check thread direction, thread diameter, and overall dimensions against the removed component before installation. After replacement, a professional wheel alignment is recommended to restore proper steering geometry.

Quality Assurance

Delphi subjects its steering components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. TA5373 is built using OE-focused material and dimensional analysis to support fitment consistency for the listed Dodge applications.