Delphi TA5396 Steering Tie Rod End - Left Outer

Delphi TA5396 Left Outer Tie Rod End

Delphi TA5396 is a steering tie rod end built for the left outer position on select Mazda Millenia models. It uses a bent, standard-replacement design with a pre-greased, coated finish and high-strength steel housing for dependable steering linkage service.

Fits 1995-2002 Mazda Millenia, left outer. This Delphi TA5396 tie rod end is engineered with OE-focused dimensional and material analysis to support proper fit and steering response on the Mazda Millenia.

Key Features

• Part number: TA5396
• Steering tie rod end for the left outer position
• Pre-greased and non-greaseable design
• Coated finish with black exterior
• High-strength steel housing and steel tie rod material
• Bent style construction
• Mounting hardware included
• Clockwise thread direction on both ends

Detailed Description

Delphi TA5396 is a standard replacement steering tie rod end for the left outer side of the Mazda Millenia from 1995 through 2002. It features a male end 1, female end 2, and threaded stud construction, with a chloroprene rubber dust boot and plastic bearing material. The part is pre-greased from the factory and does not include a grease fitting, which helps simplify routine service on the steering linkage.

Delphi applies OE-based testing and material analysis to its aftermarket steering components, including exposure to extreme temperatures and salt spray testing for corrosion resistance. This part cross-references MOOG Chassis Products ES3429 for the same application.

Common Issues This Part May Address

• Excessive steering play at the left front wheel
• Clunking or looseness from worn steering linkage components
• Uneven tire wear caused by a worn outer tie rod end
• Steering wander or reduced directional stability
• Failed inspection due to steering component wear

Installation Notes and Tips

Fits 1995-2002 Mazda Millenia, left outer. Verify thread direction, stud dimensions, and overall length before installation. After replacement, a professional wheel alignment is recommended to restore correct steering geometry and tire wear characteristics. Confirm the steering knuckle and adjacent linkage components are in serviceable condition before final assembly.

Quality Assurance

Delphi backs this steering component with OE-focused engineering, dimensional verification, and durability testing intended to support consistent aftermarket performance. The part is built to withstand severe temperature extremes and corrosion exposure during validation.