Delphi TA5415 Steering Tie Rod End - Left Inner

Delphi TA5415 Left Inner Tie Rod End

Delphi TA5415 is a standard replacement steering tie rod end for the left inner position on select Ford E-150 applications. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and service requirements of the original part.

• Fits 2003-2006 Ford E-150, left inner
• Fits 2003-2005 Ford E-150 Club Wagon, left inner
• Fits 1992-2002 Ford E-150 Econoline, left inner
• Fits 1992-2002 Ford E-150 Econoline Club Wagon, left inner
• Pre-greased with grease fitting included for serviceable maintenance
• Dust boot included to help protect the joint from contamination
• Steel housing and steel tie rod construction with coated finish
• Male threaded ends with clockwise thread direction
• Mounting hardware included

OE-Style Steering Construction

This Delphi steering tie rod end is engineered for the left inner steering location and built for direct replacement service on Ford E-150, Ford E-150 Club Wagon, Ford E-150 Econoline, and Ford E-150 Econoline Club Wagon models. Delphi subjects its steering components to extreme temperature cycling and extended salt-spray exposure, then verifies dimensions and materials to support OE-level fit and function. Part number TA5415 also cross-references MOOG Chassis Products DS1288 for the same application.

Common Steering Issues It Can Address

• Excessive steering play or looseness at the inner tie rod location
• Uneven tire wear caused by worn steering linkage components
• Clunking or knocking from the front steering system
• Imprecise steering response during lane changes or turns
• Corrosion-related wear on the steering linkage

Installation Notes and Tips

Verify left inner position, thread direction, and thread diameter before installation. Delphi TA5415 uses a bent design, male ends, and a threaded stud configuration, so alignment should be checked after replacement. Because this part is greaseable and includes a grease fitting, service the joint according to the vehicle maintenance schedule after installation. Delphi TA5415 is a direct-fit steering tie rod end for Ford E-150 applications, but final alignment is recommended whenever steering linkage parts are replaced.

Quality Assurance

Delphi applies OE engineering standards to its aftermarket steering portfolio and validates parts through dimensional and material analysis, temperature testing below -40 degrees C and above 120 degrees C, and 720 hours of salt-spray exposure. That testing supports consistent fitment and corrosion resistance for daily service use.