Delphi TA5440 Steering Tie Rod End - Left Outer

OE-Style Steering Tie Rod End

Delphi TA5440 is a premium steering tie rod end for the left outer position on select Dodge Charger, Dodge Challenger, and Chrysler 300 applications. It is built with OE-focused dimensional and material analysis to support proper steering geometry and consistent fitment.

Fits 2011-2022 Dodge Charger, left outer. Fits 2017-2021 Dodge Challenger, left outer. Fits 2011-2020 Chrysler 300, left outer.

Key Features

• Part number TA5440
• Left outer steering tie rod end
• Pre-greased design
• Dust boot included
• Steel housing and steel tie rod construction
• Coated black finish
• Male and female threaded ends with clockwise thread direction
• Standard replacement grade
• Non-adjustable, non-greaseable design

Detailed Description

Delphi TA5440 is engineered as a standard replacement steering tie rod end for vehicles that require a left outer steering linkage component. The bent steel design, pre-greased bearing surface, and included dust boot help support smooth articulation and protection from road contamination. Delphi validates its steering components through extreme temperature exposure and salt-spray testing, along with dimensional and material analysis to help maintain OE-level compatibility. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

For shoppers searching for a Dodge Charger left outer tie rod end, Chrysler 300 steering tie rod end, or Dodge Challenger outer tie rod replacement, TA5440 provides a direct-fit service part for the listed applications. The Delphi TA5440 is a practical choice when replacing worn steering linkage components on 2011-2022 Dodge Charger, 2017-2021 Dodge Challenger, and 2011-2020 Chrysler 300 models.

What It Helps Address

• Loose or imprecise steering feel from a worn outer tie rod end
• Clunking or play in the front steering linkage
• Uneven tire wear caused by steering component wear
• Steering pull or wandering related to worn linkage joints
• Dust and contamination intrusion at the steering joint

Installation Notes

Verify left outer position, thread size, and vehicle application before installation. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear characteristics. Inspect related steering and suspension components at the same time, including the inner tie rod, boots, and control arm joints, to confirm the repair addresses the full source of looseness.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering portfolio and subjects parts to temperature and corrosion testing to evaluate durability under demanding conditions. Part number TA5440 is built to match the listed OE-style application requirements for the specified Dodge and Chrysler vehicles.