Delphi TA5470 Steering Tie Rod End - Rear Inner

Delphi TA5470 Rear Inner Tie Rod End

Delphi TA5470 is a standard replacement steering tie rod end for rear inner applications on select Chevrolet Silverado 1500, Silverado 1500 HD, Silverado 2500, GMC Sierra 1500, Sierra 1500 HD, and Sierra 2500 models. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and fit requirements of the original part.

Key Features

• Part number: TA5470
• Rear inner steering tie rod end
• Straight design with adjustable construction
• Steel housing and steel tie rod material
• Pre-greased for service-ready installation
• Black coated finish for added corrosion resistance
• Male-to-male end configuration
• Mounting hardware included
• Compatible with clockwise thread direction on both ends

Detailed Description

Delphi TA5470 is engineered for rear inner steering service on 2002-2005 Chevrolet Silverado 1500, 2005 Chevrolet Silverado 1500 HD, 2002-2003 Chevrolet Silverado 1500 HD, 2002-2005 GMC Sierra 1500, 2005 GMC Sierra 1500 HD, 2002-2003 GMC Sierra 1500 HD, 2002-2004 Chevrolet Silverado 2500, and 2002-2004 GMC Sierra 2500. The design uses a steel housing, steel tie rod, and POM bearing material to support consistent steering movement and proper alignment retention. Delphi tests steering components across extreme temperature and salt-spray exposure conditions to verify durability under demanding road environments. This part cross-references MOOG Chassis Products EV800285 for the same application. Part number TA5470 is a direct reference for buyers searching for a rear inner tie rod end for Silverado and Sierra steering repair.

What It Helps Address

• Loose or imprecise rear steering response
• Uneven tire wear caused by worn steering linkage
• Clunking or play from a worn inner tie rod end
• Alignment instability after steering component wear
• Replacement needs on Silverado and Sierra rear inner steering systems

Installation Notes and Tips

Verify the rear inner position and thread specifications before installation. TA5470 is pre-greased and does not include a grease fitting or dust boot. Because it is adjustable, final alignment should be checked and set after installation to restore proper steering geometry on the vehicle.

Quality Assurance

Delphi applies OE-level engineering methods to its aftermarket steering portfolio, including dimensional and material analysis for fit consistency. The component is tested for temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure to evaluate corrosion resistance and durability.