Delphi TA5493 Steering Tie Rod End - Right Outer

Delphi TA5493 Right Outer Tie Rod End

Delphi TA5493 is a standard replacement steering tie rod end built for the right outer position. It is engineered with OE-focused dimensional and material analysis to match the original steering geometry on select BMW applications, including 2001-2005 BMW 325xi and 2001-2005 BMW 330xi.

Key Features

• Right outer steering tie rod end for select BMW 325xi and 330xi models
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint from road contamination
• Steel tie rod and steel housing with coated finish
• Bent design with threaded stud construction
• Mounting hardware included
• Clockwise thread direction at both ends
• OE-style replacement part number TA5493

Detailed Description

Delphi TA5493 is a right outer steering tie rod end for 2001-2005 BMW 325xi and 2001-2005 BMW 330xi applications. It uses a steel housing and steel tie rod with a coated finish, plus a chloroprene rubber dust boot and pre-greased joint for service-ready installation. Delphi applies OE-level dimensional and material analysis to support proper fitment and steering response, and the part is tested for temperature extremes and salt-spray exposure to reflect demanding undercar conditions. This part cross-references Beck/Arnley 101-6877 for the same application.

Common Problems This Part Can Address

• Loose or vague steering feel at the right front wheel
• Clunking or knocking from worn steering linkage components
• Uneven toe settings caused by tie rod end wear
• Boot damage that allows contamination into the steering joint
• Steering play during lane changes, braking, or low-speed turns

Installation Notes and Tips

Fits 2001-2005 BMW 325xi, right outer. Fits 2001-2005 BMW 330xi, right outer. Confirm the right outer position before installation and inspect the adjacent steering components, alignment settings, and thread engagement during replacement. Because this is a threaded steering component, a professional wheel alignment is recommended after installation. Delphi TA5493 also cross-references MOOG Chassis Products ES800805 for the same application.

Quality Assurance

Delphi builds this steering tie rod end using OE-focused engineering and validation methods. The part is exposed to temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing, to evaluate durability in harsh conditions.