Delphi TA5548 Steering Tie Rod End - Right or Right Outer

Delphi TA5548 Steering Tie Rod End

Delphi TA5548 is a straight steering tie rod end built for right-side outer steering applications. It combines a steel housing and steel bearing material with a coated finish, pre-greased construction, a grease fitting, and a dust boot to support dependable steering linkage service.

For drivers searching for a right outer tie rod end for select vehicle applications, Delphi TA5548 brings OE-focused dimensional and material analysis to the aftermarket steering category. It is a standard replacement part for vehicles that require a male-to-male, threaded steering tie rod end with clockwise thread direction on both ends.

Key Features

• Part number TA5548
• Steering tie rod end for right, right outer position
• Straight design with male end connections
• Steel housing, steel bearing material, and steel tie rod construction
• Coated finish for added surface protection
• Pre-greased with grease fitting included
• Dust boot included with chloroprene rubber material
• Mounting hardware included
• Standard replacement grade
• Interchanges with MOOG Chassis Products ES3476

Detailed Description

Delphi TA5548 is engineered as a steering tie rod end for the right outer steering position where a straight, threaded replacement is required. The part measures 185.0 mm in length, uses a 1.125 in tube diameter, and features threaded ends with 14 TPI on end 1 and 12 TPI on end 2. End 1 uses a 0.875 in thread diameter, while end 2 uses a 1.125 in thread diameter. The threaded stud design and included dust boot help maintain a secure steering connection and protect the joint from contamination.

Delphi applies OE-level dimensional and material analysis to its steering portfolio and subjects parts to extreme temperature and salt-spray testing to verify durability. This makes TA5548 a practical choice for steering service on vehicles that call for a right outer tie rod end, including applications searched as Delphi TA5548 tie rod end, right outer steering tie rod end, and steering linkage replacement for select make/model fitments. Vehicle shoppers comparing Honda Civic steering parts or other make/model-specific steering repairs should verify application details in the vehicle catalog before ordering.

This part cross-references MOOG Chassis Products ES3476 for the same application.

Common Problems This Part Can Address

• Excessive steering play or looseness at the outer tie rod
• Clunking or knocking from the front steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel wander or poor directional stability
• Damaged dust boot or contaminated tie rod joint

Installation Notes and Tips

Confirm the vehicle’s required position before installation; TA5548 is listed for the right and right outer steering position. Match thread direction, thread diameter, and stud style to the original part, and inspect the steering linkage, alignment settings, and adjacent components during replacement. After installation, a professional wheel alignment is recommended to restore steering geometry.

For fitment-based searches, use the vehicle catalog to confirm whether Delphi TA5548 is the correct right outer tie rod end for your application. It is commonly referenced in searches for Delphi TA5548, steering tie rod end replacement, and right outer tie rod end for compatible Honda Civic steering service.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its aftermarket steering parts. TA5548 is tested across extreme temperature ranges and salt-spray exposure, and Delphi’s dimensional and material analysis is used to support OE-style fit and function in the intended application.