Delphi TA5554 Steering Tie Rod End - Outer

Delphi TA5554 Outer Tie Rod End

Delphi TA5554 is an outer steering tie rod end built as a standard replacement for select Dodge trucks and SUVs. It uses OE-focused dimensional and material analysis to support proper steering linkage fitment, with testing that covers extreme temperatures and extended salt-spray exposure.

Key Features

• Outer steering tie rod end for steering linkage service
• Standard replacement design with straight configuration
• Steel housing and steel tie rod material with coated finish
• Pre-greased, greaseable, and supplied with a grease fitting
• Dust boot included with chloroprene rubber construction
• Male threaded ends with threaded stud design
• Mounting hardware included
• Delphi part number TA5554

Detailed Description

Delphi TA5554 is engineered for the outer position in the steering system and is listed for 1975-1978 Dodge D100, 1977-1978 Dodge D150, 1976-1978 Dodge D200, and 1975-1978 Dodge Ramcharger. It also fits 1975 Dodge D200 with left hand threads and 3000 lb or 3300 lb front axle notes. This outer tie rod end is built with a steel housing, coated black finish, and pre-greased construction to support consistent steering service. Delphi applies OE-level dimensional and material analysis to help match aftermarket fitment to the original application, and the part is tested across severe temperature and corrosion conditions.

This part cross-references MOOG Chassis Products ES428L for the same application.

Common Steering Issues It Can Address

• Excessive steering play at the outer linkage point
• Clunking or looseness from worn tie rod end joints
• Uneven toe settings caused by worn steering components
• Steering response that feels vague or inconsistent
• Boot damage or grease loss at the outer tie rod end

Installation Notes and Tips

Verify the vehicle’s year, model, and steering configuration before installation, especially on 1975 Dodge D200 applications with left hand threads and specific front axle notes. Inspect the mating steering components, then align the front end after replacement to restore correct toe settings. Delphi TA5554 is a straight, non-adjustable outer tie rod end, so final alignment should be performed after installation.

Quality Assurance

Delphi uses OE safety technology and aftermarket steering expertise to build this replacement part. The component is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to help validate corrosion resistance and durability.