Delphi TA5616 Steering Tie Rod End - Right Outer

Delphi TA5616 Steering Tie Rod End

Delphi TA5616 is a front right outer steering tie rod end built for OE-style replacement performance. It is engineered for the steering demands of the Acura TLX and Honda Accord applications listed below, with dimensional and material analysis used to support proper fit and consistent steering response.

Key Features

• Fits 2015-2020 Acura TLX, right outer
• Fits 2013-2017 Honda Accord, right outer
• Part number: TA5616
• Pre-greased design for ready-to-install service
• Steel housing and steel tie rod construction
• Coated black finish for added corrosion resistance
• Bent style with threaded stud design
• Mounting hardware included
• Standard replacement grade

Detailed Description

This Delphi steering tie rod end is built to replace the outer steering linkage connection on the right side of the front suspension. Delphi applies OE-focused engineering to its aftermarket steering portfolio, with testing that includes extreme temperature exposure from below -40 degrees C to over 120 degrees C and salt spray exposure for 720 hours. The TA5616 also uses a pre-greased, non-greaseable design with a chloroprene rubber dust boot material and POM bearing material to support smooth steering movement and long-term service in daily driving conditions. If you are sourcing a steering tie rod end for a 2015-2020 Acura TLX or a 2013-2017 Honda Accord, TA5616 is a direct-fit service part for the right outer position.

This part cross-references Beck/Arnley 101-7882 and MOOG ES801000 for the same application.

Common Problems This Part Can Help Address

• Excessive steering play at the front right outer linkage
• Clunking or looseness from worn steering components
• Uneven steering feel caused by worn tie rod end joints
• Improper toe control from degraded outer steering hardware
• Corrosion-related wear on exposed steering linkage parts

Installation Notes and Tips

Confirm the vehicle position before installation, since this part is listed for the front right outer or right outer steering location. After replacement, a professional wheel alignment is recommended to restore correct toe settings and steering wheel centering. Verify thread direction, thread diameter, and overall dimensions against the removed part before assembly on the Acura TLX or Honda Accord application.

Quality Assurance

Delphi backs this steering component with OE-based design and validation practices, including dimensional and material analysis for fit consistency and environmental testing for temperature and corrosion resistance. Part number TA5616 is built as a standard replacement steering tie rod end for the listed applications.