Delphi TA5639 Steering Tie Rod End - Outer

Delphi TA5639 Outer Tie Rod End

Delphi TA5639 is a standard replacement outer steering tie rod end built for direct-fit service on select Dodge applications. It combines an adjustable straight design with greaseable serviceability, a dust boot, and coated SAE 1045 construction for dependable steering linkage repair.

Key Features

• Outer steering tie rod end for select Dodge Charger, Dart, and Lancer applications
• Adjustable, straight design with male threaded ends
• Grease fitting included for serviceable maintenance
• Dust boot included with chloroprene rubber boot material
• SAE 1045 housing and tie rod material with coated finish
• Mounting hardware included
• Clockwise thread direction on both ends
• Standard replacement grade, black finish

Detailed Description

Delphi TA5639 is engineered as an outer steering tie rod end for vehicles that need precise steering linkage restoration. It measures 105.0 mm from stud center to end and uses a 0.563-inch end 2 thread diameter with 18 threads per inch, making it a practical replacement for steering service on 1962-1969 Dodge Dart, 1966-1969 Dodge Charger, and 1962 Dodge Lancer outer positions. This part cross-references MOOG Chassis Products ES319R for the same application.

Delphi applies OE-focused dimensional and material analysis to help maintain fit and steering geometry. The part is tested for extreme temperature exposure and salt spray resistance, supporting durability in demanding road conditions. If you are searching for a Delphi TA5639 outer tie rod end for a Dodge Charger or Dodge Dart steering repair, this part is built to match the original service requirements closely.

Common Repair Uses

• Loose or wandering steering feel
• Clunking or play in the outer steering linkage
• Uneven front tire wear caused by worn steering components
• Steering wheel off-center after linkage wear
• Restoring steering response on older Dodge Charger and Dodge Dart models

Installation Notes and Tips

Fits 1966-1969 Dodge Charger, outer. Fits 1962-1969 Dodge Dart, outer. Fits 1962 Dodge Lancer, outer. Verify thread direction, thread diameter, and overall length before installation, and perform a professional alignment after replacing the outer tie rod end. Inspect the mating steering components for wear so the new part is not installed against damaged hardware.

Quality Assurance

Delphi builds this steering component using OE-oriented engineering and validation methods, including dimensional and material analysis plus environmental testing for heat and corrosion exposure. The result is a standard replacement outer tie rod end intended to meet the service demands of the listed Dodge applications.