Delphi TA5655 Steering Tie Rod End - Left Outer

Delphi TA5655 Left Outer Tie Rod End

Delphi TA5655 is a standard replacement steering tie rod end built for the left outer position. It combines OE-based dimensional and material analysis with Delphi’s steering portfolio testing to support consistent fit and steering response in service applications.

Key Features

• Left outer steering tie rod end for direct replacement use
• Greaseable design for serviceable lubrication
• Dust boot included to help protect the joint from contamination
• Mounting hardware included
• OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40°C and above 120°C
• Exposed to 720 hours of salt spray during validation

Detailed Description

The Delphi TA5655 steering tie rod end is engineered as a standard replacement part for the left outer steering position. Delphi applies OE development experience to its aftermarket steering components, using dimensional and material checks to help maintain proper compatibility between the replacement part and the original steering geometry. This part number, TA5655, is built for buyers looking for a direct steering service part with a greaseable joint, dust boot protection, and included mounting hardware. It is a practical choice for steering repairs on vehicles such as Chrysler 300 and Dodge Charger applications where the left outer tie rod end is the service point.

This part cross-references Monroe Shocks & Struts (e.g., 172286) and MOOG Chassis Products (e.g., ES800719) for the same application.

What It Helps Fix

• Loose or wandering steering feel
• Clunking or play from the outer tie rod area
• Uneven front tire wear caused by steering linkage wear
• Steering pull related to worn left outer tie rod components
• Contamination at the joint from a damaged or missing boot

Installation Notes and Tips

Install Delphi TA5655 at the left outer steering position and verify alignment after replacement. Compare the original part length and end configuration before installation, and inspect the steering linkage, inner tie rod, and related hardware for wear. This tie rod end is greaseable, so follow the vehicle’s service interval and lubrication requirements after installation. Confirm application details against the vehicle’s steering setup before ordering, especially on Chrysler 300 and Dodge Charger models.

Quality Assurance

Delphi validates its steering parts through extreme-temperature testing and extended salt-spray exposure to evaluate durability in demanding conditions. The brand also uses OE-based analysis to support fit and material consistency in the aftermarket steering portfolio. Part number TA5655 reflects that OE-focused approach for steering service work.