Delphi TA5659 Steering Tie Rod End - Inner

Delphi TA5659 Inner Tie Rod End

Delphi TA5659 is a standard replacement inner steering tie rod end built for precise steering linkage service on select Infiniti applications. It is engineered using Delphi OE-focused dimensional and material analysis to support proper fit and consistent steering response in the Infiniti G35 and G37.

Key Features

• Inner steering tie rod end for steering gear and related components
• Standard replacement design for direct service use
• Male end 1 configuration
• Mounting hardware included
• No dust boot included
• Non-greaseable design
• Dimensions: 179.8 length, 39.0 width

Fitment Details

Fits 2007-2008 Infiniti G35, inner. Fits 2009 Infiniti G37, inner. Fits 2010 Infiniti G37, inner, to 05/2010. Delphi TA5659 is a direct-fit steering tie rod end for these listed applications, including Infiniti G35 inner tie rod end replacement and Infiniti G37 inner steering service.

This part cross-references MOOG Chassis Products EV800607 for the same application.

What This Part Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering feel
• Uneven front-end steering response during lane changes or turns
• Clunking or knocking from steering linkage wear
• Restoring proper steering geometry after component wear

Installation Notes

Verify vehicle year, model, and inner position before installation. Inspect adjacent steering components, alignment settings, and related hardware for wear before returning the vehicle to service. Because this is a non-greaseable inner tie rod end, routine lubrication is not required.

Quality Assurance

Delphi applies OE-based engineering to its aftermarket steering portfolio and validates parts through extreme temperature exposure and extended salt-spray testing. The brand also uses dimensional and material analysis to improve OE-to-aftermarket compatibility for the Delphi TA5659.