Delphi TA5676 Steering Tie Rod End - Left Outer

Delphi TA5676 Left Outer Tie Rod End

Delphi TA5676 is a standard replacement steering tie rod end built for the left outer position. It combines OE-based dimensional and material analysis with durability testing for demanding steering service on Dodge Ram trucks.

Key Features

• Left outer steering tie rod end for direct replacement service
• Greaseable design for routine lubrication maintenance
• Dust boot included to help protect the joint from contamination
• Mounting hardware included
• Length: 156.0
• Male end 1 gender
• Standard replacement grade

Application Details

Compatible with 2008 Dodge Ram 1500, left outer, with 8 lug wheels and tapered hole mounted steering damper; 2003-2008 Dodge Ram 2500, left outer, 6.10in length and tapered hole mounted steering damper; 2003-2008 Dodge Ram 3500, left outer, 6.10in length and tapered hole mounted steering damper; and 2006-2007 Dodge Ram 1500, left outer. This Delphi TA5676 tie rod end is built for steering systems that need precise linkage at the outer end of the left side.

This part cross-references MOOG Chassis Products ES3625 for the same application.

What It Helps Address

• Loose or worn steering feel at the left outer tie rod position
• Front-end play that can affect steering response
• Uneven tire wear caused by steering linkage wear
• Noisy or unstable steering components under load
• Contamination at the joint from damaged or missing boot protection

Installation Notes

Verify vehicle configuration, including wheel and steering damper notes, before installation. After replacing the tie rod end, inspect alignment settings and confirm steering wheel centering. Delphi TA5676 is greaseable, so follow the vehicle service schedule for lubrication after installation.

Quality Assurance

Delphi applies OE-focused engineering to its steering portfolio and subjects parts to extreme temperature and salt-spray testing to evaluate durability. The brand also uses dimensional and material analysis to support fit and compatibility with the intended OE application.