Delphi TA5684 Steering Tie Rod End - Inner
OE Quality 60-Day Returns
Delphi

Delphi TA5684 Steering Tie Rod End - Inner

Brand Delphi TA5684
Position Inner
Dust Boot Included No
End 1 Gender Male
Greaseable No
Item Grade Standard Replacement
Length 285.8
Mounting Hardware Included Yes
Position(s) Front Inner
Width 41.0
Fits Hummer · 1 vehicle

Standard replacement. OE expertise applied to aftermarket steering parts.

OE performance. Tested for extreme temperatures and 720 hours of salt spray.

Dimensional and material analysis helps ensure compatibility.

Cross-references Dorman - Premium TI91130PR, 15217991 and TI91130 for the same application. See all 3.

$38.44Free shipping
In stock · usually ships same day before 1pm CST
Step 1 — Confirm fitment
Free return shipping if it doesn't fit when you check fitment here first.

Select your vehicle to confirm fitment
Verify this part fits before purchasing — free returns if it doesn't
Step 2 — Quantity
Order total $38.44
Free shipping to the continental U.S.
Free returns within 60 days if it doesn't fit when fitment is verified.
Not what you need? See all Steering Tie Rod End options

Delphi TA5684 Front Inner Tie Rod End

Delphi TA5684 is a standard replacement steering tie rod end for the front inner position on the 2006 Hummer H3, 1st Design. Built from Delphi OE-focused dimensional and material analysis, it is engineered for direct replacement fitment and consistent steering linkage performance.

Key Features

  • Front inner steering tie rod end for the 2006 Hummer H3, 1st Design
  • Standard replacement part for steering linkage service
  • Male end 1 configuration
  • Mounting hardware included
  • Non-greaseable design
  • Length: 285.8 mm; Width: 41.0 mm
  • Dust boot not included

Detailed Description

Delphi TA5684 is built for the front inner steering location on the 2006 Hummer H3 and follows OE-based dimensional and material requirements for proper alignment and steering response. Delphi subjects its steering components to extreme temperature cycling and extended salt-spray exposure to verify durability in demanding conditions. This part cross-references Dorman - Premium TI91130PR for the same application.

What It Helps Address

  • Loose or imprecise steering feel at the front inner linkage
  • Clunking or play caused by worn tie rod end components
  • Uneven tire wear related to steering linkage wear
  • Steering correction issues after suspension or front-end service
  • Replacement needs for a worn 2006 Hummer H3 front inner tie rod end

Installation Notes and Tips

Verify the front inner position and 1st Design application before installation. Inspect related steering and suspension components, then perform a professional wheel alignment after replacement. Delphi TA5684 includes mounting hardware, and the non-greaseable design means no routine lubrication service is required.

Quality Assurance

Delphi applies OE engineering methods to its aftermarket steering portfolio and validates parts through dimensional and material analysis, temperature testing below -40 degrees C and above 120 degrees C, and 720 hours of salt-spray exposure. This helps support consistent fit and corrosion resistance for steering service on the Hummer H3.

Related reading

This part fits 1 vehicle
Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
YearMakeModelPositionNotes
2006HummerH3Inner1st Design
Directly replaces or cross-references 3 part numbers
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.
Dorman - Premium — TI91130PR15217991TI91130