Delphi TA5685 Steering Tie Rod End - Inner

Delphi TA5685 Inner Tie Rod End

Delphi TA5685 is a standard replacement inner steering tie rod end built for precise steering linkage service on select Kia Amanti applications. It uses Delphi OE-focused dimensional and material analysis to support proper fit and consistent steering response.

Compatible with 2004-2005 Kia Amanti, inner, and 2006 Kia Amanti, inner, to 06/30/2006. This Delphi tie rod end is part number TA5685 and is engineered for the steering gear and related components category.

Key Features

• Inner steering tie rod end for select Kia Amanti models
• Standard replacement grade for steering linkage repair
• Male end 1 configuration
• Mounting hardware included
• Non-greaseable design
• Dust boot not included
• Length: 198.5

Detailed Description

Delphi TA5685 is built for inner steering service where accurate linkage geometry matters. Delphi applies OE-based engineering practices to its aftermarket steering portfolio, with testing that includes extreme temperature exposure from below -40 degrees C to over 120 degrees C and salt spray exposure for corrosion resistance evaluation. The result is a replacement steering tie rod end intended to match OE dimensions and material characteristics as closely as possible for the listed Kia Amanti fitments. If you are replacing a worn inner tie rod end on a 2004-2006 Kia Amanti, TA5685 provides a direct service part reference for that application. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering feel
• Uneven tire wear caused by steering linkage wear
• Clunking or knocking from the steering system
• Restoration of proper toe control after front-end service

Installation Notes and Tips

Verify the vehicle is a 2004-2005 Kia Amanti or a 2006 Kia Amanti built to 06/30/2006 before installation. Confirm the inner steering position and compare the removed part’s dimensions, thread engagement, and end configuration to TA5685. After installation, perform a professional wheel alignment to restore steering geometry and tire wear characteristics.

Quality Assurance

Delphi uses OE-oriented testing and dimensional analysis for its steering components, including temperature cycling and extended salt spray exposure, to evaluate durability and fit consistency for aftermarket replacement use.