Delphi TA5700 Steering Tie Rod End - Outer

Delphi TA5700 Steering Tie Rod End

Delphi TA5700 is a front outer steering tie rod end built as a standard replacement for precise steering linkage service. It is engineered with OE-focused dimensional and material analysis to help maintain proper fit on the vehicle and consistent steering response.

Fits 2006 Hummer H3, outer, 1st design.

Key Features

• Delphi steering tie rod end, part number TA5700
• Front outer position
• Straight design with adjustable construction
• Steel housing and steel tie rod material
• Pre-greased with dust boot included
• Coated black finish for added surface protection
• Female end 1 and male end 2 configuration
• Mounting hardware included

Detailed Description

Delphi TA5700 is a steering tie rod end for the front outer location on the 2006 Hummer H3, 1st design. It uses a straight, adjustable layout with 14.0 mm thread diameter at both ends, clockwise thread direction, and a threaded stud type for direct steering linkage service. The steel housing, steel tie rod, and chloroprene rubber dust boot support durable operation, while the pre-greased design helps reduce initial service prep. Delphi applies OE-based dimensional and material analysis to support close match-up between the original part and the aftermarket replacement. This part cross-references MOOG Chassis Products ES800763 for the same application.

Common Issues This Part Can Address

• Excessive steering play at the front outer linkage
• Clunking or looseness from worn tie rod end joints
• Uneven toe settings caused by steering linkage wear
• Steering wheel wander from degraded front suspension geometry
• Boot damage that exposes the joint to contamination

Installation Notes and Tips

Verify the vehicle is a 2006 Hummer H3 with the outer, 1st design application before ordering Delphi TA5700. After installation, perform a professional alignment to restore toe settings and steering wheel center. Inspect the mating steering components for wear before final assembly, and confirm thread engagement and torque against service specifications.

Quality Assurance

Delphi tests steering components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure plus extended salt-spray testing. The brand’s OE-focused engineering and material analysis support consistent replacement quality for the Hummer H3 front outer steering tie rod end application.