Delphi TA5752 Steering Tie Rod End - Inner

Delphi Inner Steering Tie Rod End TA5752

Delphi TA5752 is a standard replacement inner steering tie rod end built for precise steering linkage service on select Ford applications. It is engineered with OE-focused dimensional and material analysis to support proper fit and consistent steering response.

Key Features

• Inner steering tie rod end for steering gear and related components
• Straight design with male and female end configuration
• Phosphate finish for corrosion resistance
• Standard replacement grade for direct service use
• No grease fitting included
• Delphi OE-based testing includes extreme temperature exposure and salt spray validation

Detailed Description

This Delphi steering tie rod end, part number TA5752, is designed for the inner position on the steering linkage. It is a direct-fit replacement for 2004-2007 Ford Freestar inner steering applications and is built to match OE dimensions and material requirements for proper compatibility with the original steering system. Delphi applies OE safety technology and aftermarket steering expertise to this component, with validation that includes temperatures below -40 degrees C, above 120 degrees C, and 720 hours of salt spray exposure. This part cross-references Ford 3F2Z 3280-AA and MOOG EV800307 for the same application.

Common Repair Uses

• Restores steering linkage precision when the inner tie rod end is worn
• Addresses looseness or play in the steering system
• Helps correct steering wander or inconsistent road feel
• Supports repair of clunking or knocking from the front steering assembly
• Provides a replacement for corrosion-damaged steering components

Installation Notes and Tips

Fits 2004-2007 Ford Freestar, inner. Verify the steering side and linkage condition before installation, and inspect related steering components for wear at the same time. Because this is an inner tie rod end, alignment service is typically required after replacement to restore proper steering geometry. Delphi TA5752 should be matched to the vehicle’s original application and position before installation.

Quality Assurance

Delphi uses OE-based engineering, dimensional checks, and material analysis to support fit and performance consistency. The part is tested under severe temperature and corrosion conditions to help confirm durability in steering service.