Delphi TA5767 Steering Tie Rod End - At Pitman Arm or Left Outer

OE-Style Steering Tie Rod End

Delphi TA5767 is a standard replacement steering tie rod end built for precise steering linkage service on select Jeep applications. It combines OE-based dimensional analysis with material testing to support consistent fit and dependable steering response.

Fits 1984-1990 Jeep Cherokee, Left Outer. Fits 1986-1990 Jeep Comanche, Left Outer. Fits 1984-1990 Jeep Wagoneer, Left Outer. Fits 1987-1990 Jeep Wrangler, At Pitman Arm, with Left Hand Threads.

Key Features

• Part number TA5767
• Steering tie rod end for steering, gear and related components service
• Straight, standard replacement design
• Steel housing and steel tie rod construction
• Pre-greased with grease fitting included
• Dust boot included for joint protection
• Coated black finish
• Non-adjustable design
• Male end configuration with threaded stud
• End 1 thread direction: counterclockwise; End 2 thread direction: clockwise

Detailed Description

Delphi TA5767 is engineered for steering systems that require OE-style dimensional accuracy and material consistency. Delphi applies the same development approach used in its OE safety technology, then validates the part through temperature exposure from below -40 degrees C to over 120 degrees C and extended salt-spray testing. That process helps support fitment stability and corrosion resistance in demanding driving conditions. This tie rod end is pre-greased, greaseable, and supplied with a dust boot and mounting hardware, making it a practical replacement for worn steering linkage components on Jeep Cherokee, Jeep Comanche, Jeep Wagoneer, and Jeep Wrangler models listed above. This part cross-references Monroe Shocks & Struts (e.g., 52000598) for the same application.

Common Problems This Part Can Address

• Loose or vague steering feel from a worn tie rod end
• Front-end play caused by joint wear at the steering linkage
• Clunking or knocking from deteriorated steering components
• Grease loss or contamination at the steering joint
• Corrosion-related replacement needs in exposed steering hardware

Installation Notes and Tips

Confirm the vehicle position before ordering, since this part is listed for Left Outer and At Pitman Arm applications depending on model. Verify thread direction, thread diameter, and steering linkage orientation against the removed part before installation. After replacement, inspect alignment and steering linkage condition to help restore proper steering geometry.

Quality Assurance

Delphi backs this steering tie rod end with OE-focused engineering, dimensional analysis, and environmental testing intended to support consistent aftermarket performance. The part is built to match the application requirements of the listed Jeep Cherokee, Jeep Comanche, Jeep Wagoneer, and Jeep Wrangler fitments.