Delphi TA5982 Steering Tie Rod End - Left Outer

Delphi TA5982 Left Outer Tie Rod End

Delphi TA5982 is a steering tie rod end built for the left outer position on select Subaru applications. It combines OE-based dimensional and material analysis with a coated steel housing, dust boot protection, and standard replacement construction for direct steering linkage service.

Key Features

• Left outer steering tie rod end for select Subaru WRX STI, Legacy, and Outback applications
• Steel housing with coated finish for corrosion resistance
• Dust boot included to help protect the joint from road contamination
• Threaded stud design with clockwise thread direction on both ends
• Standard replacement grade with mounting hardware included
• Non-adjustable, non-greaseable design
• Delphi part number TA5982

Detailed Description

Delphi TA5982 is engineered as a steering tie rod end for the left outer side, with fitment coverage for 2015-2019 Subaru Legacy, 2015-2019 Subaru Outback, 2017 Subaru WRX STI, and 2018-2020 Subaru WRX STI. This part number TA5982 is built with a steel tie rod body, plastic bearing material, and a chloroprene rubber dust boot to support steering linkage service in demanding road conditions. Delphi applies OE-level dimensional and material analysis to help maintain proper part compatibility, and the component is tested across extreme temperature and salt-spray exposure ranges to validate durability.

This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application.

Vehicle Fitment

• Fits 2019-2020 Subaru WRX STI, left outer.
• Fits 2017 Subaru WRX STI, left outer.
• Fits 2015-2019 Subaru Legacy, left outer.
• Fits 2015-2019 Subaru Outback, left outer.
• Fits 2018 Subaru WRX STI, left outer; fits vehicles with normal power steering.

What It Helps Address

• Steering play or looseness at the left outer tie rod end
• Clunking or knocking from worn steering linkage components
• Uneven front tire wear caused by excessive steering end wear
• Loose or imprecise steering response during lane changes and turns
• Dust boot damage that can expose the joint to contamination

Installation Notes and Tips

Confirm left outer position, thread size, and vehicle application before installation. After replacement, inspect the steering linkage and perform a wheel alignment to restore correct toe settings. Delphi TA5982 includes mounting hardware and a dust boot, and the non-greaseable design does not require routine lubrication.

Quality Assurance

Delphi uses OE-focused engineering for its steering portfolio and validates parts through temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. That process supports consistent fit and durability for Subaru steering service.