Delphi TA6312 Steering Tie Rod End - Left Outer

Delphi TA6312 Left Outer Tie Rod End

Delphi TA6312 is a standard replacement steering tie rod end for the left outer position. It is built for 2009-2013 INFINITI FX50 and 2009-2012 INFINITI FX35 applications, with OE-focused dimensional and material analysis to support proper fit and steering response.

• Left outer steering tie rod end
• Standard replacement grade for direct service use
• Dust boot included to help protect the joint area
• Mounting hardware included
• Non-greaseable design
• Length: 226.8

OE-Focused Steering Replacement

Delphi TA6312 is engineered using the brand’s OE steering expertise and validated through extreme temperature and salt-spray testing. That approach helps the part meet the demands of daily driving while maintaining dimensional compatibility with the original steering layout on INFINITI FX50 and INFINITI FX35 models. This Delphi TA6312 tie rod end is a direct service part for the left outer steering position.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 2009-2013 INFINITI FX50, left outer.
• Fits 2009-2012 INFINITI FX35, left outer.

What It Helps Address

• Loose or imprecise steering feel at the front end
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering wheel wander or poor directional stability
• Service replacement for damaged dust boot or joint wear

Installation Notes

Verify left outer position before installation and confirm alignment after replacement. Compare the original part length and mounting points to the vehicle’s steering linkage before final assembly. Delphi TA6312 includes mounting hardware and a dust boot, which supports a cleaner service replacement on the specified INFINITI FX50 and FX35 applications.

Quality Assurance

Delphi applies OE-based engineering and durability testing to its steering portfolio, including exposure to extreme cold, high heat, and extended salt-spray testing. The part is built as a standard replacement for the listed applications and is backed by Delphi’s OE-oriented manufacturing approach.