Delphi TA6332 Steering Tie Rod End - Left Outer

OE-Style Steering Tie Rod End for Nissan Quest

The Delphi TA6332 is a premium steering tie rod end built for the left outer position on select Nissan Quest models. It combines OE-focused dimensional analysis with materials chosen for consistent steering response and dependable fitment.

Fits 2011-2017 Nissan Quest, left outer. This Delphi TA6332 tie rod end is engineered for direct replacement use on the steering linkage where precise alignment and road feel matter.

Key Features

• Part number TA6332
• Fits left outer steering position
• Pre-greased design
• Dust boot included
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Bent style with threaded stud design
• OE-focused dimensional and material analysis for fit consistency
• Tested for extreme temperature exposure and salt-spray resistance

Detailed Description

Delphi TA6332 is a standard replacement steering tie rod end for the left outer side of the 2011-2017 Nissan Quest. It uses a steel housing, steel tie rod material, and a coated finish, with a pre-greased, non-greaseable design and an included dust boot to help protect the joint from contamination. The bent configuration and threaded ends support proper steering linkage geometry, while Delphi’s OE-based engineering approach helps maintain dimensional accuracy between the original part and the replacement.

Delphi applies OE safety technology and aftermarket steering expertise to this component, with validation that includes temperature exposure below -40 degrees C and above 120 degrees C, plus extended salt-spray testing. If you are replacing a worn Nissan Quest outer tie rod end, TA6332 provides a direct-fit solution for restoring steering precision. This part cross-references Beck/Arnley 101-7947 for the same application.

Common Problems This Part Can Help Solve

• Excessive steering play or looseness at the front end
• Uneven tire wear caused by worn steering linkage components
• Clunking or knocking from the outer tie rod area
• Poor steering response or wandering on the road
• Alignment issues related to a worn left outer tie rod end

Installation Notes and Tips

Install Delphi TA6332 on the left outer steering position only, and verify thread direction and dimensions before assembly. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear control. Inspect the mating steering components, boots, and fasteners for wear during service, especially on a Nissan Quest with higher mileage.

Quality Assurance

Delphi builds this steering tie rod end using OE-oriented engineering and validation methods to support consistent replacement quality. The part is tested for harsh temperature extremes and corrosion exposure, and its dimensional analysis is used to improve compatibility with the original steering system on the Nissan Quest.