Delphi TA6357 Steering Tie Rod End - Right Outer

Delphi TA6357 Right Outer Tie Rod End

Delphi TA6357 is a standard replacement steering tie rod end for the right outer position. It is built for 2009-2011 Kia Borrego applications and reflects Delphi’s OE-focused steering expertise for direct-fit service work.

Key Features

• Standard replacement steering tie rod end for the right outer position
• Fits 2009-2011 Kia Borrego, right outer
• OE-oriented dimensional and material analysis for application match
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation
• Delphi TA6357 cross-references Beck/Arnley 101-6786 for the same application

Detailed Description

Delphi TA6357 is a steering tie rod end engineered for the right outer location on the 2009-2011 Kia Borrego. Delphi applies OE development experience to its aftermarket steering portfolio, with attention to dimensional accuracy and material selection to support proper fit and steering response. If you are searching for a right outer tie rod end for Kia Borrego 2009, 2010, or 2011 models, TA6357 is the direct replacement part number to reference.

Delphi validates steering components under demanding environmental conditions, including extreme heat, extreme cold, and extended salt-spray exposure. That testing approach supports durability in real-world road conditions and helps maintain consistent steering performance over time. Delphi TA6357 is also referenced by Beck/Arnley 101-6786 for the same application.

Common Repair Symptoms

• Loose or wandering steering on the right front side
• Clunking or play in the steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel off-center after front-end service
• Visible wear at the outer tie rod end on a Kia Borrego

Installation Notes and Tips

Confirm the vehicle is a 2009-2011 Kia Borrego with the right outer steering position before ordering Delphi TA6357. After installation, perform a professional wheel alignment to restore steering geometry and tire wear characteristics. Inspect related steering and suspension components at the same time to identify additional wear.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering parts, including dimensional and material analysis plus environmental testing for temperature and corrosion exposure. That process supports consistent fit and dependable service for the Delphi TA6357 tie rod end.