Delphi TA6388 Steering Tie Rod End - Inner

Inner Steering Tie Rod End for Hyundai Genesis and Equus

Delphi TA6388 is an inner steering tie rod end built for OE-style steering service on select Hyundai applications. It is engineered for the inner position and supports precise steering linkage performance on Hyundai Genesis and Hyundai Equus models.

Key Features

• Inner steering tie rod end for steering gear and related components
• OE-focused dimensional and material analysis for fitment consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation
• Direct replacement part number TA6388 for select Hyundai steering applications

Detailed Description

Delphi applies OE engineering knowledge to its aftermarket steering portfolio, and TA6388 reflects that approach with attention to compatibility, durability, and dimensional accuracy. This inner tie rod end is listed for 2009-2014 Hyundai Genesis, 2011 Hyundai Equus from 01/05/2011, and 2012-2014 Hyundai Equus in the inner steering position. It is a practical choice when servicing steering linkage wear on Hyundai Genesis and Hyundai Equus vehicles that require an inner tie rod end replacement.

This part cross-references Hyundai OE number 57724-3M500 for the same application.

What It Helps Address

• Loose or imprecise steering feel from worn inner linkage components
• Steering play caused by wear at the inner tie rod end
• Uneven steering response during lane changes or turns
• Noisy steering linkage movement from deteriorated joints
• Restoration of steering geometry after tie rod service

Installation Notes and Tips

Install TA6388 only on the confirmed inner steering position listed for the vehicle. After replacement, inspect the steering linkage, verify alignment settings, and confirm that the steering wheel is centered. For Hyundai Genesis and Hyundai Equus applications, match the model year and the 01/05/2011 note where applicable before installation.

Quality Assurance

Delphi validates steering components through extreme temperature cycling and extended salt spray exposure, along with dimensional and material analysis to support OE-level compatibility. TA6388 is backed by Delphi’s OE-focused aftermarket engineering approach.