Delphi TA6400 Steering Tie Rod End - Inner

Delphi TA6400 Inner Steering Tie Rod End

Delphi TA6400 is an inner steering tie rod end built for OE-style steering service and dimensional consistency. It is a straight, male-to-male tie rod end with a black finish and no grease fitting, making it a direct-fit style replacement for select steering gear applications.

For buyers searching for a Delphi steering tie rod end, TA6400, or an inner tie rod end for OE replacement service, this part is backed by Delphi’s aftermarket steering expertise and material analysis standards.

Key Features

• Part number: TA6400
• Steering tie rod end for inner steering linkage service
• Straight design with male end connections
• Black finish
• No grease fitting included
• Built using OE-focused dimensional and material analysis
• Tested for temperature extremes below -40°C and above 120°C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation

Detailed Description

Delphi TA6400 is engineered for steering systems that require an inner tie rod end with OE-level fit and material compatibility. Delphi applies its original-equipment experience to the aftermarket steering portfolio, helping maintain proper steering geometry and secure linkage operation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Search terms such as Delphi TA6400 inner tie rod end, steering tie rod end replacement, and OE-style steering linkage part are commonly used by technicians and parts buyers looking for a direct replacement in steering gear service. It is also relevant for vehicle-specific searches such as Honda Civic steering tie rod end replacement and compatible steering linkage parts for select applications.

What It Helps Address

• Loose or imprecise steering response
• Excessive play in the inner steering linkage
• Uneven tire wear caused by worn steering components
• Clunking or knocking from the steering gear area
• Restoration of steering alignment stability after tie rod wear

Installation Notes and Tips

Inspect the full steering linkage, boots, and alignment settings before installation. Because this is an inner steering tie rod end, final alignment should be checked after replacement. Confirm end gender, straight design, and position match the vehicle’s steering configuration before ordering. Delphi TA6400 is listed as an inner position part, so verify application details against the vehicle’s steering system and service information.

Quality Assurance

Delphi uses OE-based testing and engineering methods for its steering portfolio, including extreme temperature exposure and extended salt-spray validation. The brand’s dimensional and material analysis is intended to support consistent OE-to-aftermarket compatibility. Part number TA6400 reflects Delphi’s steering component standards for service replacement applications.