Delphi TA6403 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod End

Delphi TA6403 is a standard replacement steering tie rod end for the inner position on select Honda and Acura applications. Built with OE-focused dimensional and material analysis, it supports precise steering linkage service for 2013-2017 Honda Accord and 2015-2020 Acura TLX models.

Delphi tests steering components across extreme temperature and corrosion conditions to help maintain OE-level fit and function in demanding road environments.

Key Features

• Inner steering tie rod end for select Honda Accord and Acura TLX applications
• Straight design with male-to-male threaded ends
• Steel housing and steel tie rod construction with coated finish
• Pre-greased for initial service readiness
• Mounting hardware included
• Standard replacement part number TA6403

Detailed Description

This Delphi steering tie rod end is engineered for the inner steering position and built to match OE dimensions and material requirements. The steel housing, coated finish, and pre-greased construction support dependable steering linkage service, while the threaded stud design helps maintain secure connection at the steering rack side. Delphi TA6403 is a direct-fit steering component for 2013-2017 Honda Accord, inner, and 2015-2020 Acura TLX, inner.

This part cross-references Beck/Arnley 101-7817 for the same application.

Common Steering Issues It Can Help Address

• Excessive steering play or looseness at the inner tie rod
• Clunking or knocking from the steering linkage
• Uneven tire wear caused by worn steering components
• Imprecise steering response during lane changes or turns
• Failed inspection due to steering system wear

Installation Notes and Tips

Verify inner tie rod length, thread diameter, and position before installation. Delphi TA6403 is a straight, non-adjustable inner tie rod end with a 14.0 mm end thread diameter and threaded stud type. Because the dust boot is not included, inspect the existing boot and related steering rack components during service. A professional alignment is recommended after steering linkage replacement.

Quality Assurance

Delphi applies OE expertise to its aftermarket steering portfolio and validates parts through temperature cycling below -40 degrees C and above 120 degrees C, plus extended salt-spray exposure. That testing supports corrosion resistance and fit consistency for long-term steering service.