Delphi TA6414 Steering Tie Rod End - Left Outer

Delphi TA6414 Left Outer Tie Rod End

The Delphi TA6414 steering tie rod end is a standard replacement part for the left outer position on select Volvo models. Built with a steel housing, coated finish, and pre-greased design, it supports precise steering response for Volvo XC60, XC90, V60 Cross Country, and V90 Cross Country applications.

Key Features

• Part number: TA6414
• Steering tie rod end for the left outer position
• Steel tie rod and steel housing construction
• Coated black finish for added surface protection
• Pre-greased for ready-to-install service
• Male and female end configuration with bent design
• Mounting hardware included
• Standard replacement grade

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering portfolio, using dimensional and material analysis to match OE fit and function. The TA6414 is built for direct replacement service on 2016-2025 Volvo XC90, 2018-2025 Volvo XC60, 2017-2019 and 2021-2025 Volvo V90 Cross Country, and 2019 and 2021-2025 Volvo V60 Cross Country left outer steering applications. It features a 12.0 mm end 1 thread diameter, 18.0 mm end 2 thread diameter, clockwise thread direction on both ends, and a Polyoxymethilen (POM) bearing material for controlled movement.

This part cross-references Monroe Shocks & Struts (e.g., 31476415) for the same application. If you are replacing a worn Volvo XC90 left outer tie rod end or servicing a Volvo XC60 steering linkage, Delphi TA6414 provides the OE-style dimensions and materials needed for a proper repair.

Common Problems It Can Help Address

• Loose or vague steering feel
• Front-end wandering or poor directional stability
• Uneven tire wear caused by steering linkage wear
• Clunking or play from a worn outer tie rod end
• Steering alignment issues after component wear

Installation Notes and Tips

Verify left outer position, thread sizes, and vehicle application before installation. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. The bent design and included mounting hardware support service on the specified Volvo steering applications.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. These validation steps support OE-level durability expectations for the TA6414 in daily driving conditions.