Delphi TA6456 Steering Tie Rod End - Inner

Delphi TA6456 Inner Steering Tie Rod End

Delphi TA6456 is a standard replacement inner steering tie rod end built for precise steering linkage service on select INFINITI applications. It uses a straight steel housing, pre-greased construction, and included mounting hardware to support a clean OE-style replacement on the inner steering position.

Compatible With 2011-2013 INFINITI M37, 2011-2013 INFINITI M56, 2012-2013 INFINITI M35h, 2014-2019 INFINITI Q70, and 2015-2019 INFINITI Q70L. This Delphi TA6456 tie rod end is engineered for the inner steering location and matches the dimensional and material requirements needed for proper fitment.

Key Features

• Inner steering tie rod end for select INFINITI vehicles
• Straight design with steel tie rod and steel housing
• Pre-greased for ready-to-install service
• Male end 1 and male end 2 thread configuration
• Clockwise (right) thread direction on both ends
• Standard replacement grade
• Black finish
• Mounting hardware included

Detailed Description

Delphi TA6456 is built for the inner steering position and follows OE-focused dimensional and material analysis to help maintain proper steering linkage geometry. Delphi subjects steering components to extreme temperature exposure from below -40 degrees C to over 120 degrees C, along with extended salt-spray testing, to evaluate durability in demanding conditions. The result is a replacement tie rod end suited for service on INFINITI M37, M56, M35h, Q70, and Q70L models where accurate steering response and secure connection at the inner tie rod location are required.

This part cross-references Beck/Arnley 101-7944 and MOOG Chassis Products EV801324 for the same application.

What This Part Helps Address

• Loose or imprecise steering feel from worn inner steering linkage
• Clunking or play in the steering system
• Uneven tire wear caused by steering component wear
• Restoration of proper steering connection at the inner tie rod location
• Replacement of a damaged or corroded steering tie rod end

Installation Notes and Tips

Verify vehicle application by year, model, and inner steering position before installation. Inspect the steering rack, outer tie rod ends, and alignment settings during service, since wear in adjacent components can affect steering performance. Because this part is pre-greased and does not include a grease fitting or dust boot, install it as a sealed replacement component and complete a professional wheel alignment after installation.

Quality Assurance

Delphi applies OE engineering standards to its aftermarket steering portfolio and validates parts through dimensional and material analysis for fit consistency. The TA6456 is tested for temperature extremes and salt-spray exposure to support durability in real-world driving conditions.