Delphi TAL10004 Alignment Camber Kit - Rear Lower

Rear Lower Alignment Camber Kit for Kia and Hyundai

Delphi TAL10004 is a rear lower alignment camber kit built for select Kia Sedona and Hyundai Entourage applications. It combines OE-focused dimensional and material analysis with testing for temperature extremes and salt exposure to support consistent suspension alignment service.

Key Features

• Alignment camber kit for the rear lower suspension position
• Light suspension grade type for the listed applications
• Black shim color
• Bolt length: 112.903 mm / 4.445 in
• OE-based fit and material analysis for aftermarket replacement accuracy
• Tested for operation below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

Delphi TAL10004 is an alignment camber kit for rear lower suspension service on the 2006-2012 Kia Sedona, 2014 Kia Sedona, and 2007-2009 Hyundai Entourage. It is engineered around Delphi’s OE expertise, with dimensional and material analysis used to match the original part’s compatibility requirements. The result is a direct-fit suspension alignment component for correcting rear lower camber-related service needs on these vehicles. This part cross-references MOOG Chassis Products K100347 for the same application.

What It Helps Address

• Rear wheel camber misalignment after suspension service
• Uneven tire wear related to rear alignment issues
• Pulling or tracking concerns tied to rear suspension geometry
• Need for a replacement rear lower camber adjustment component
• Service replacement on Kia Sedona and Hyundai Entourage rear lower positions

Installation Notes and Tips

• Fits 2014 Kia Sedona, rear lower.
• Fits 2006-2012 Kia Sedona, rear lower.
• Fits 2007-2009 Hyundai Entourage, rear lower.
• Verify rear suspension condition and alignment settings before and after installation.
• Confirm bolt length and shim orientation against the vehicle’s service specifications during setup.

Quality Assurance

Delphi validates steering and suspension components through OE-focused testing that includes extreme temperature cycling and extended salt-spray exposure. TAL10004 is built using Delphi’s dimensional and material analysis process to support consistent fitment and service performance on the listed vehicles.