Delphi TAL10023 Alignment Cam Bolt Kit - Front

Delphi TAL10023 Alignment Cam Bolt Kit for Mazda MX-5 Miata

Delphi TAL10023 is a front alignment cam bolt kit built for 2006-2015 Mazda MX-5 Miata applications. It uses a cam bolt adjustment type with an adjustable angle to help restore or fine-tune front suspension alignment settings after service or wear.

Engineered with Delphi OE-focused dimensional and material analysis, this front cam bolt kit is made for consistent fitment on the Mazda MX-5 Miata and related front suspension hardware applications. The Delphi TAL10023 includes a nut, a grease fitting, and a gray finish for service-ready replacement.

• Part number: TAL10023
• Alignment cam bolt kit for front suspension use
• Fits 2006-2015 Mazda MX-5 Miata, front
• Adjustment type: cam bolt
• Adjustable angle for alignment correction
• Nut included
• Grease fitting included
• Thread length: 1.70 in. / 43.18 mm
• Bolt length: 4.00 in. / 101.60 mm
• Cam thickness: 0.17 in. / 4.19 mm

Detailed Product Information

Delphi TAL10023 is a front alignment cam bolt kit for Mazda MX-5 Miata models from 2006 through 2015. It is built for suspension hardware service where front camber adjustment is needed, and it cross-references Monroe Shocks & Struts 172286 for the same application. The Delphi TAL10023 is a practical OE-style replacement choice when front alignment hardware needs to be renewed on a Mazda MX-5 Miata.

Common Uses

• Front alignment correction after suspension service
• Replacement for worn or seized cam bolt hardware
• Restoring proper front wheel alignment settings
• Addressing uneven tire wear caused by alignment drift
• Replacing damaged front suspension fasteners

Installation Notes and Tips

Install on the front suspension only and verify alignment settings after installation. Confirm bolt length, thread length, and cam thickness against the original hardware before assembly. Because this is alignment hardware, a professional alignment check is recommended after replacement on the Mazda MX-5 Miata.

Quality Assurance

Delphi applies OE-focused engineering and testing to its steering and suspension portfolio. This part is evaluated for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to support durability in demanding service conditions.