Delphi TAL10089 Alignment Camber Arm - Rear Lower

Rear Lower Alignment Camber Arm for Ford, Mazda, and Mercury

Delphi TAL10089 is a rear lower alignment camber arm built for vehicles that need precise rear suspension geometry. It fits select Ford Escape, Mazda Tribute, and Mercury Mariner applications, including 2001-2012 Ford Escape, rear lower, and is engineered with Delphi OE-focused dimensional and material analysis for accurate replacement fit.

Key Features

• Rear lower alignment camber arm for suspension alignment service
• Fits 2001-2012 Ford Escape, rear lower
• Fits 2001-2006 Mazda Tribute, rear lower
• Fits 2008-2011 Mazda Tribute, rear lower
• Fits 2005-2011 Mercury Mariner, rear lower
• Delphi TAL10089 is tested for temperature extremes below -40 degrees C and above 120 degrees C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation
• OE-focused design supports dimensional and material compatibility with the original part

Detailed Description

Delphi TAL10089 is an alignment camber arm for the rear lower suspension position on select Ford Escape, Mazda Tribute, and Mercury Mariner models. It is built using Delphi’s OE engineering approach, with attention to fit, material selection, and dimensional accuracy so the replacement part matches the vehicle’s original suspension layout. This part cross-references K100072 and Mevotech Supreme CMK80115 for the same application.

Common Issues This Part Can Address

• Rear camber angle out of specification after suspension wear
• Uneven tire wear caused by rear alignment drift
• Clunking or looseness from a worn rear lower arm
• Difficulty holding alignment settings on Ford Escape, Mazda Tribute, or Mercury Mariner
• Suspension geometry changes after component fatigue or corrosion

Installation Notes and Tips

Install TAL10089 in the rear lower position and verify alignment after replacement. Compare the removed arm to the new part before installation, and inspect related bushings, fasteners, and mounting points for wear or damage. Final alignment measurements should be checked after the suspension is reassembled.

Quality Assurance

Delphi applies OE-focused testing to this suspension component, including extreme-temperature exposure and extended salt-spray validation. The brand’s dimensional and material analysis supports consistent fitment for the listed Ford Escape, Mazda Tribute, and Mercury Mariner applications.