Delphi TC1007 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

OE-Style Front Left Lower Control Arm

Delphi TC1007 is a front left lower suspension control arm and ball joint assembly built for OE-style replacement on select Toyota and Scion applications. It combines a stamped steel arm, press-in ball joint, and included bushings to restore front suspension geometry and steering response.

Compatible with 2000-2005 Toyota MR2 Spyder, 2004 Scion xA, 2004 Scion xB, and 2000-2003 Toyota Echo front left lower positions, this Delphi TC1007 assembly is built for direct-fit service on the listed vehicles.

Key Features

• Delphi TC1007 suspension control arm and ball joint assembly
• Front left lower position
• Stamped steel control arm construction with black finish
• Press-in ball joint with threaded stud
• Pre-greased design
• Bushings included with rubber and steel construction
• Mounting hardware included
• Standard replacement grade

Detailed Description

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering and suspension portfolio, and this TC1007 assembly reflects that approach. The arm is built from stamped steel for consistent fit and strength, with a press-in ball joint and rubber-and-steel bushings to match the service requirements of the original suspension layout. Delphi also validates parts through temperature and corrosion exposure testing, including sub-zero and high-heat conditions plus extended salt spray exposure, to verify durability in demanding environments.

This part cross-references MOOG Chassis Products K500118 for the same application. It is a direct replacement choice for Toyota MR2 Spyder, Toyota Echo, and Scion xA/xB front left lower suspension service where the original control arm assembly has worn or loosened.

What It Helps Fix

• Clunking or knocking from the front suspension
• Excessive play in the lower control arm or ball joint
• Uneven tire wear caused by worn suspension geometry
• Loose or unstable steering feel
• Vibration or wandering during braking and cornering

Installation Notes

Install on the front left lower suspension position only for the listed vehicles. Verify ball joint thread diameter, mounting hole diameter, and arm dimensions against the original part before installation. Because the assembly is pre-greased and includes mounting hardware, it is ready for service once the old component is removed and the mounting points are inspected for wear or damage.

Quality Assurance

Delphi uses OE-based engineering and validation methods for its aftermarket steering and suspension parts. TC1007 is tested for temperature extremes and salt spray exposure, and its materials are analyzed for OE-to-aftermarket compatibility on the specified applications.