Delphi TC1075 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

OE-Style Front Right Upper Control Arm

The Delphi TC1075 is a standard replacement suspension control arm and ball joint assembly for the front right upper position. It is built for 1996-2000 Honda Civic and 1997-2000 Acura EL applications, with OE-focused dimensional and material analysis to support proper fit and suspension geometry.

Delphi applies OE safety technology and aftermarket steering expertise to this part, with testing that includes extreme temperature exposure below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. The result is a front right upper control arm assembly engineered for everyday road use on Honda Civic and Acura EL platforms.

Key Features

• Part number TC1075
• Fits 1996-2000 Honda Civic, front right upper
• Fits 1997-2000 Acura EL, front right upper
• Stamped steel control arm construction with black finish
• Pre-greased design with no grease fitting
• Press-in ball joint with threaded stud
• Bushings included with natural rubber material
• Mounting hardware included
• Standard replacement, light suspension grade
• Non-adjustable, non-greaseable design

Detailed Description

Delphi TC1075 is a front right upper suspension control arm and ball joint assembly made for direct replacement on select Honda Civic and Acura EL models. The stamped steel arm, press-in ball joint, and rubber bushings are specified to match OE-style suspension requirements, while the pre-greased construction helps simplify service. Delphi’s dimensional and material analysis supports compatibility between the OE and aftermarket part, making this assembly a practical choice for restoring front suspension function on the Civic and EL.

This part cross-references MOOG Chassis Products RK90450 for the same application.

What It Helps Address

• Front-end looseness or wandering caused by worn upper control arm components
• Clunking or knocking from a deteriorated ball joint or bushing
• Uneven tire wear related to suspension wear
• Steering response issues from excess play in the front right upper suspension
• Restoring proper suspension alignment after component wear

Installation Notes and Tips

Install the Delphi TC1075 on the front right upper position only for the listed Honda Civic and Acura EL applications. Verify mounting hole diameter, arm length, and ball joint stud dimensions against the original part before installation. Because this assembly uses a press-in ball joint and includes bushings, proper suspension service tools and alignment inspection are recommended after replacement.

Quality Assurance

Delphi subjects its OE-based steering and suspension parts to extreme temperature and corrosion testing, including sub-zero and high-heat exposure and extended salt spray testing. The TC1075 is built as a standard replacement part with OE-focused dimensional and material validation for consistent fit and performance.