Delphi TC1088 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm Assembly

Delphi TC1088 is a front left lower suspension control arm and ball joint assembly for select Suzuki Swift models. It is built as a standard replacement with OE-focused dimensions and materials for direct service on the front suspension.

Fits 1989-1994 Suzuki Swift, front left lower.

Key Features

• Pre-greased for initial service readiness
• Stamped steel control arm construction with black finish
• Press-in ball joint mounting type
• Bushings included with rubber and steel bushing material
• Mounting hardware included
• Non-adjustable, non-greaseable design
• Delphi part number TC1088

Detailed Description

Delphi TC1088 is engineered as a suspension control arm and ball joint assembly for the front left lower position on 1989-1994 Suzuki Swift applications. The stamped steel arm uses a press-in ball joint design and includes bushings for a complete replacement of the worn suspension link. Delphi applies OE dimensional and material analysis to help maintain proper fit and suspension geometry, and the part is tested across extreme temperature and salt-spray exposure conditions to verify durability in demanding environments. If you are replacing a worn front suspension arm on a Suzuki Swift, TC1088 provides a direct-service solution built around OE-style specifications.

This part cross-references MOOG Chassis Products RK622717 and Mevotech Supreme CMS5302 for the same application.

Common Repair Symptoms

• Clunking or knocking from the front suspension
• Excessive play in the front left lower control arm
• Uneven tire wear caused by worn suspension geometry
• Steering wander or reduced front-end stability
• Failed or deteriorated bushings and ball joint wear

Installation Notes

Verify front left lower fitment before installation on 1989-1994 Suzuki Swift models. Inspect the mounting points, fasteners, and surrounding suspension components for wear or damage before assembly. Because the ball joint is press-in, proper service tools and alignment procedures are recommended after installation to restore correct suspension geometry.

Quality Assurance

Delphi uses OE-based engineering, dimensional checks, and material analysis to support fit and function. The part is also subjected to temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing, to evaluate durability in service.