Delphi TC1117 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Delphi TC1117 Front Right Lower Control Arm

Delphi TC1117 is a standard replacement suspension control arm and ball joint assembly for the front right lower position. It is built with a stamped steel arm, pre-greased construction, and included bushings and mounting hardware for a direct-fit service replacement on select Mitsubishi Mirage and Dodge Colt applications.

Key Features

• Fits the front right lower suspension position
• Stamped steel control arm with black finish
• Pre-greased assembly for service-ready installation
• Press-in ball joint with threaded stud
• Bushings included with natural rubber construction
• Mounting hardware included
• Light-duty suspension grade
• Standard replacement part number TC1117

Detailed Description

Delphi TC1117 is engineered as a front right lower control arm and ball joint assembly for 1993-1996 Mitsubishi Mirage and 1993-1995 Dodge Colt models. Delphi applies OE-focused dimensional and material analysis to help maintain proper fit and suspension geometry, while the steel stamped arm and press-in ball joint design support dependable replacement service. The assembly is pre-greased and uses a threaded ball joint stud, with no grease fitting and no adjustability.

This part cross-references Dorman OE Solutions 520-840 for the same application. The Delphi TC1117 part number is also commonly searched alongside Mirage and Colt front suspension repair needs, especially when replacing worn lower control arm components.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play from worn control arm bushings
• Loose or unstable steering feel
• Uneven tire wear caused by suspension wear
• Ball joint wear at the front right lower corner

Installation Notes and Tips

Fits 1993-1996 Mitsubishi Mirage, front right lower. Fits 1993-1995 Dodge Colt, front right lower. Verify mounting hole diameter, arm length, and position before installation. Because the ball joint is press-in and the arm is not adjustable, correct alignment should be checked after replacement. Delphi TC1117 is a direct replacement for the specified front suspension location and should be installed with attention to torque specifications and suspension preload procedures.

Quality Assurance

Delphi subjects its steering and suspension parts to extreme temperature and salt-spray testing, along with dimensional and material analysis, to support OE-level fit and durability expectations in aftermarket service.