Delphi TC1297 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm for Nissan Sentra

Delphi TC1297 is a front left lower suspension control arm and ball joint assembly for select 2000-2006 Nissan Sentra models. Built as a standard replacement with OE-focused dimensional and material analysis, it is made to match the original suspension layout and restore proper front-end geometry.

For shoppers searching for a Nissan Sentra front left lower control arm, Delphi TC1297 offers a stamped steel construction, pre-greased ball joint, and rubber bushings for direct replacement service.

Key Features

• Part number: TC1297
• Fits 2000-2006 Nissan Sentra, front left lower
• Stamped steel control arm construction
• Press-in ball joint mounting type
• Pre-greased design
• Rubber bushing material
• Black finish
• Standard replacement grade
• Three mounting holes

Detailed Description

Delphi TC1297 is engineered for the front left lower position on the Nissan Sentra, covering model years 2000 through 2006. It combines a steel stamped arm with a press-in ball joint and rubber bushings to support stable suspension movement and consistent steering response. Delphi applies OE-based testing and dimensional analysis to help ensure the aftermarket part aligns with original equipment fit and function. This part cross-references MOOG Chassis Products RK620359 for the same application.

Because the assembly is pre-greased and not greaseable, it is built for straightforward replacement service rather than routine lubrication. The Delphi TC1297 is a practical choice when replacing a worn front left lower control arm on a Nissan Sentra and restoring suspension integrity.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the front left lower control arm
• Uneven tire wear caused by worn suspension geometry
• Loose or unstable steering feel
• Worn ball joint or deteriorated rubber bushings

Installation Notes and Tips

Confirm vehicle fitment by year, make, model, and front left lower position before installation. Because the ball joint is press-in, proper suspension service tools are typically required for removal and installation. Inspect related components such as bushings, fasteners, and alignment angles during replacement, and perform a wheel alignment after installation.

Quality Assurance

Delphi tests steering and suspension components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure plus extended salt-spray testing. The brand also uses OE dimensional and material analysis to support fit and compatibility for aftermarket replacement parts.