Delphi TC1465 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm for Mercedes-Benz B200

Delphi TC1465 is a front left lower suspension control arm and ball joint assembly for select 2006-2011 Mercedes-Benz B200 models. Built as a standard replacement, it combines stamped steel construction, pre-greased components, and included bushings to support consistent front suspension performance.

Delphi applies OE-focused dimensional and material analysis to help the part match the original application on Mercedes-Benz B200 front left lower suspension service. Delphi TC1465 is tested for temperature extremes and salt-spray exposure to reflect demanding underbody conditions.

• Fits 2006-2011 Mercedes-Benz B200, front left lower
• Delphi part number TC1465
• Stamped steel control arm construction
• Pre-greased design with no grease fitting
• Bushings included with mounting hardware included
• Black finish with standard replacement grade
• Ball joint integrated into the assembly

Detailed Product Overview

This suspension control arm and ball joint assembly is built for the front left lower position and is intended to restore proper suspension geometry on the Mercedes-Benz B200. The stamped steel arm uses rubber, steel, and aluminum bushing materials for a factory-style service replacement, while the pre-greased ball joint helps simplify installation and initial operation. Delphi TC1465 is also cross-referenced to Beck/Arnley 101-5003 for the same application.

Common Problems This Part Can Address

• Front-end clunking or knocking from worn control arm bushings
• Loose or inconsistent steering feel caused by ball joint wear
• Uneven tire wear related to suspension geometry changes
• Excessive front suspension play on the left lower side
• Noise or vibration from deteriorated lower arm components

Installation Notes and Tips

Install this part in the front left lower position only. Verify the vehicle application against the Mercedes-Benz B200 year range before installation, and inspect adjacent suspension components such as tie rods, struts, and mounting points for wear or damage. Because the assembly is pre-greased and not greaseable, no grease fitting service is required after installation.

Quality Assurance

Delphi uses OE-oriented testing and material validation for its steering and suspension parts. This assembly is evaluated for extreme temperature exposure and extended salt-spray resistance, with dimensional checks used to support fitment consistency between OE and aftermarket applications.