Delphi TC1486 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm Assembly

Delphi TC1486 is a front left lower suspension control arm and ball joint assembly built for OE-style replacement on select Saab applications. It combines an aluminum control arm, pre-greased construction, and integrated bushings to support consistent steering and suspension response.

Compatible with 1995-1998 Saab 900 and 1999-2003 Saab 9-3, front left lower. Delphi TC1486 is a direct-fit suspension service part for drivers replacing worn front-end components on these Saab models.

Key Features

• Part number TC1486
• Front left lower position
• Aluminum control arm with casting/forged construction
• Pre-greased design
• Bushings included with rubber bushing material
• Threaded ball joint stud
• Standard replacement grade for light-duty suspension use
• Black finish

OE-Style Replacement Details

Delphi applies OE engineering and dimensional analysis to its aftermarket steering and suspension portfolio, helping the part align with factory fit and material expectations. TC1486 is built for the front left lower location and uses a threaded ball joint stud, two mounting holes, and a non-adjustable layout for straightforward replacement on Saab 900 and Saab 9-3 front suspension systems. This part cross-references Dorman - OE Solutions 520-597 for the same application.

Common Problems This Part Can Help Address

• Excessive front-end looseness or wandering
• Clunking or knocking from a worn lower control arm
• Uneven tire wear caused by suspension wear
• Steering instability during braking or cornering
• Ball joint or bushing wear at the front left lower suspension point

Installation Notes

Verify vehicle year, make, model, and front left lower position before installation. Inspect adjacent suspension components, alignment angles, and mounting points during service. Because mounting hardware is not included, reuse or replace fasteners as required by the vehicle service procedure. A professional alignment is recommended after control arm replacement.

Quality Assurance

Delphi tests suspension components for temperature extremes and salt-spray exposure, and uses dimensional and material analysis to support OE-level fitment consistency. TC1486 is built as a standard replacement part for Saab front suspension service.