Delphi TC1504 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

Delphi TC1504 is a standard replacement suspension control arm and ball joint assembly for the front right lower position. It is built with stamped steel construction, pre-greased components, and included bushings to support consistent steering and suspension response on select Chevrolet Aveo, Chevrolet Aveo5, Pontiac G3, Pontiac G3 Wave, Pontiac Wave, Pontiac Wave5, and Suzuki Swift+ applications.

Key Features

• Stamped steel control arm construction with a black finish
• Pre-greased assembly with no grease fitting required
• Rubber and steel bushings included
• Threaded ball joint stud with mounting hardware included
• Standard replacement part for the front right lower suspension position
• Delphi OE-focused dimensional and material analysis for fit consistency

Detailed Description

Delphi TC1504 is engineered as an OE-style suspension control arm and ball joint assembly for vehicles that need precise front-end geometry and dependable lower suspension support. Delphi applies OE-level testing to aftermarket steering and suspension parts, including exposure to extreme temperatures below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing. That validation process helps confirm durability in demanding road and weather conditions. This part cross-references MOOG Chassis Products RK620165 for the same application.

Compatible With 2004-2011 Chevrolet Aveo, front right lower; 2006-2011 Chevrolet Aveo5, front right lower; 2009-2010 Pontiac G3, front right lower; 2009 Pontiac G3 Wave, front right lower; 2004-2009 Suzuki Swift+, front right lower; 2005-2008 Pontiac Wave, front right lower; and 2005-2007 Pontiac Wave5, front right lower. Delphi TC1504 is a direct-fit suspension control arm and ball joint assembly for these applications.

Common Repair Applications

• Front-end clunking or looseness from worn lower suspension joints
• Uneven tire wear caused by worn control arm bushings or ball joint wear
• Steering wander or reduced directional stability
• Suspension noise over bumps or during turning
• Restoring proper front right lower suspension geometry after wear

Installation Notes

Verify the front right lower position before installation and compare the original part to the new assembly for mounting points, ball joint stud type, and overall dimensions. Delphi TC1504 includes bushings and mounting hardware, and it is pre-greased, so no grease fitting service is required. After installation, perform a professional alignment to confirm correct suspension angles and tire wear characteristics.

Quality Assurance

Delphi uses OE-focused engineering, dimensional analysis, and material validation to support aftermarket fit and performance. The part is tested for temperature extremes and salt spray exposure to help confirm durability in real-world suspension service.