Delphi TC1923 Suspension Stabilizer Bar Link - Front Left

Front Left Stabilizer Bar Link for Sprinter

Delphi TC1923 is a front left suspension stabilizer bar link built with steel construction, ball joint ends, and a protective dust boot. It is a standard replacement for Mercedes-Benz Sprinter and Dodge Sprinter applications where precise sway bar connection and consistent front-end response matter.

Key Features

• Steel housing and steel construction for durable suspension service
• Ball joint ends on both sides for stabilizer bar connection
• Dust boot included to help protect the joint area
• Rubber bushing material with black bushing color
• Polyoxymethylene (POM) bearing material
• M10 x 1.50 bolt thread size and 137.5 mm overall length
• Standard replacement part for the front left position

Detailed Description

Delphi TC1923 stabilizer bar link is engineered for the front left side and built to match OE-style dimensions and material requirements. Delphi applies dimensional and material analysis to support fitment accuracy between original equipment and aftermarket replacement parts, and the component is tested across extreme temperature and corrosion conditions. This part cross-references MOOG Chassis Products K750277 for the same application. It is a direct-fit suspension stabilizer bar link for Mercedes-Benz Sprinter 2500, Mercedes-Benz Sprinter 1500, Mercedes-Benz Sprinter 3500, Mercedes-Benz Sprinter 3500XD, and Dodge Sprinter models listed below.

Common Issues This Part Can Address

• Front suspension clunking over bumps
• Loose or worn sway bar connection at the front left
• Excessive body roll from a deteriorated stabilizer link
• Noise caused by worn ball joint ends or damaged boots
• Uneven steering feel from front suspension wear

Installation Notes and Tips

• Verify front left fitment before installation; this part is not listed for other positions.
• Inspect adjacent sway bar bushings, control arm joints, and mounting points for wear before replacing the link.
• Confirm bolt thread size M10 x 1.50 and overall length 137.5 mm during comparison with the removed part.
• Professional installation and a post-repair alignment check are recommended after suspension work.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its aftermarket steering and suspension portfolio. TC1923 is evaluated for temperature extremes and salt-spray exposure, with material and dimensional checks used to support consistent replacement quality.

Vehicle Fitment

• Fits 2018-2022 Mercedes-Benz Sprinter 2500, front left.
• Fits 2019-2021 Mercedes-Benz Sprinter 1500, front left.
• Fits 2018-2021 Mercedes-Benz Sprinter 3500, front left.
• Fits 2018-2019 Mercedes-Benz Sprinter 3500XD, front left.
• Fits 2010-2017 Mercedes-Benz Sprinter 2500, front left, W906.
• Fits 2010-2017 Mercedes-Benz Sprinter 3500, front left, W906.
• Fits 2007-2009 Dodge Sprinter 2500, front left, W906.
• Fits 2007-2009 Dodge Sprinter 3500, front left, W906.