Delphi TC1975 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Delphi TC1975 Front Right Lower Control Arm

Delphi TC1975 is a front right lower suspension control arm and ball joint assembly built for OE-style replacement on select Chrysler, Dodge, and Plymouth compact cars. It combines a stamped steel arm, press-in ball joint, and included bushings to restore front suspension geometry and steering response.

Key Features

• Pre-greased for immediate service
• Stamped steel control arm construction with black finish
• Press-in ball joint with threaded stud type
• Bushings included with rubber and steel bushing material
• Mounting hardware included
• Standard replacement grade for front suspension service
• Non-adjustable, non-greaseable design

Detailed Description

Delphi TC1975 is engineered as a front right lower control arm assembly for vehicles that need a direct suspension replacement with OE-style dimensions and material selection. Delphi applies dimensional and material analysis to help maintain fit and compatibility, while the assembly is tested for extreme temperature exposure and salt spray resistance to support long-term durability in demanding road conditions. This part cross-references MOOG Chassis Products RK620007 for the same application.

Compatible With 2006-2010 Chrysler PT Cruiser, front right lower; 2001-2005 Chrysler PT Cruiser, front right lower; 2003-2005 Dodge Neon, front right lower; 2000-2005 Dodge Neon, front right lower; 2000-2002 Chrysler Neon, front right lower; and 2000-2001 Plymouth Neon, front right lower. Delphi TC1975 is a strong fitment match for drivers searching for a front right lower control arm for Chrysler PT Cruiser or Dodge Neon suspension repair.

Common Problems This Part Can Address

• Excessive front-end play from worn control arm bushings
• Clunking or knocking from a failing ball joint
• Uneven tire wear caused by suspension looseness
• Steering wander or poor directional stability
• Front suspension noise during braking or turning

Installation Notes and Tips

Verify the vehicle’s front right lower position and confirm the 18mm pinch bolt note where applicable before ordering. Inspect adjacent suspension components, alignment angles, and mounting points during replacement. Because the ball joint is press-in, proper service tools and alignment after installation are recommended.

Quality Assurance

Delphi uses OE-focused engineering practices for its aftermarket steering and suspension portfolio. TC1975 is built with OE compatibility in mind and is tested across extreme temperature ranges and extended salt spray exposure to support dependable performance in service.