Delphi TC2130 Suspension Stabilizer Bar Link - Front Left

Delphi TC2130 Front Left Stabilizer Link

Delphi TC2130 is a front left suspension stabilizer bar link for select Dodge Sprinter 2500, Dodge Sprinter 3500, and Mercedes-Benz Sprinter applications. Built with steel construction, ball joint ends, and a dust boot, it is a standard replacement part for restoring front suspension connection and steering response.

Key Features

• Part number: TC2130
• Front left suspension stabilizer bar link
• Steel housing and steel construction
• Ball joint ends on both sides
• Dust boot included
• Locking nuts included
• Standard replacement grade
• Bolt thread size: M10 x 1.50
• Bearing material: Polyoxymethilen (POM)
• Greaseable: No

Detailed Description

Delphi TC2130 is engineered for the front left position and matches OE-style dimensions for proper suspension geometry. Delphi applies dimensional and material analysis to support fitment consistency between OE and aftermarket applications, and this stabilizer link is tested for temperature extremes and salt-spray exposure to help verify durability in demanding road conditions. It is a direct-fit style replacement for 2003-2006 Dodge Sprinter 2500, 2003-2006 Dodge Sprinter 3500, and 2004-2006 Mercedes-Benz Sprinter models with W901, W902, and W903 configurations. If you are replacing a worn front sway bar link on a Dodge Sprinter or Mercedes-Benz Sprinter, Delphi TC2130 provides the correct front left service part reference.

This part cross-references A9053200489 for the same application.

Common Problems This Part Can Address

• Front-end clunking or rattling over bumps
• Excessive play in the stabilizer bar connection
• Loose or worn ball joint movement at the link
• Uneven suspension response during cornering
• Noise caused by a damaged dust boot or worn link assembly

Installation Notes and Tips

• Confirm front left placement before installation.
• Verify thread size M10 x 1.50 and overall length of 130 mm (5.118 in) against the removed part.
• Inspect the stabilizer bar, control arm mounting points, and adjacent bushings for wear before installing the new link.
• Torque fasteners to the vehicle manufacturer’s specification.
• After installation, check for proper suspension movement and road-test for noise or looseness.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering and suspension portfolio. TC2130 is built with steel components and tested across extreme temperature and corrosion conditions to support consistent performance in service.