Delphi TC2166 Suspension Stabilizer Bar Link - Front Right

Front Right Stabilizer Bar Link for OE-Style Handling

Delphi TC2166 is a front right suspension stabilizer bar link built with steel construction, ball joint ends, and a sealed dust boot for dependable steering and suspension response. It is a standard replacement part for select Nissan and INFINITI applications, including Rogue, Altima, Murano, Quest, Qashqai, Pathfinder, and QX60 models.

Key Features

• Steel stabilizer bar link with steel housing material
• Ball joint ends on both sides for suspension articulation
• Dust boot included to help protect the joint area
• Black rubber bushing material with POM bearing material
• Locking nuts included; M12 x 1.25 bolt thread size
• Front right position for direct-fit replacement applications
• Standard replacement grade for OE-style service

Detailed Description

Delphi TC2166 is engineered as a suspension stabilizer bar link for the front right side. Its steel body, ball joint end design, and sealed boot construction support consistent sway bar connection and suspension movement under everyday driving conditions. Delphi applies OE-focused dimensional and material analysis to help maintain proper fitment across the listed Nissan and INFINITI applications, including 2007-2013 Nissan Altima, 2008-2020 Nissan Rogue, 2009-2014 Nissan Murano, 2011-2016 Nissan Quest, 2017-2019 Nissan Qashqai, 2017-2021 Nissan Rogue Sport, 2022 Nissan Pathfinder, and 2022 INFINITI QX60.

This part cross-references Beck/Arnley 101-6720 for the same application.

What It Helps Address

• Front-end clunking or rattling from a worn stabilizer link
• Loose or inconsistent steering feel over bumps and turns
• Excess sway bar movement caused by joint wear
• Noise from deteriorated link bushings or joint seals
• Uneven suspension response on the front right side

Installation Notes and Tips

Install TC2166 on the front right position only and verify thread size, mounting points, and vehicle application before service. Because this link uses ball joint ends and includes locking nuts, proper torque and alignment checks are important after installation. For best results, inspect the opposite side and related suspension components for wear at the same time.

Quality Assurance

Delphi subjects its steering and suspension components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. This OE-focused validation helps support consistent material quality and fit accuracy for TC2166.