Delphi TC2238 Suspension Stabilizer Bar Link - Front

Front Stabilizer Bar Link for Prelude

The Delphi TC2238 is a front suspension stabilizer bar link for 1997-2001 Honda Prelude applications. It is built as a standard replacement part with a rubber bushing and non-greaseable design for direct service use in the front suspension.

Delphi applies OE-focused dimensional and material analysis to help match the original part’s fit and function. The TC2238 is also tested for temperature extremes and salt exposure to support durability in demanding road conditions.

Key Features

• Part number TC2238 for front suspension service
• Standard replacement stabilizer bar link
• Rubber bushing with black finish
• Non-greaseable design
• Regular grade construction for everyday repair use
• Compatible with 1997-2001 Honda Prelude, front

Detailed Description

Delphi TC2238 is a front suspension stabilizer bar link made for 1997-2001 Honda Prelude models. It is engineered as an OE-style replacement for the front stabilizer bar connection, helping restore proper suspension linkage performance when the original component is worn. The rubber bushing material and standard replacement grade support a direct-fit repair approach, while Delphi’s OE-based analysis helps maintain dimensional and material consistency with the original application. If you are sourcing a Delphi TC2238 for a Honda Prelude front suspension repair, this part provides a focused replacement option for the listed vehicles.

This part cross-references Beck/Arnley 101-4622 for the same application.

Common Issues This Part May Address

• Front suspension clunking or rattling from a worn stabilizer bar link
• Excessive play in the front sway bar connection
• Reduced suspension stability caused by deteriorated link bushings
• Noise over bumps from a loose or worn front linkage
• Service replacement for a damaged front stabilizer bar link on a Honda Prelude

Installation Notes and Tips

Verify the vehicle is a 1997-2001 Honda Prelude with front application before ordering. Inspect the stabilizer bar, mounting points, and surrounding suspension components for wear during replacement. Follow the vehicle service procedure and torque specifications for the front suspension linkage.

Quality Assurance

Delphi subjects this part to OE-focused validation, including extreme temperature exposure below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing. These checks support material durability and fit consistency for front suspension service.