Delphi TC2281 Suspension Stabilizer Bar Link - Front Right

Front Right Stabilizer Bar Link for OE Replacement

The Delphi TC2281 suspension stabilizer bar link is a front right OE-style replacement built for precise fit and consistent suspension response. It is engineered for 2000-2003 Nissan Maxima, 2000-2001 INFINITI I30, and 2002-2004 INFINITI I35 applications, making it a direct choice for restoring front-end stability on these vehicles.

Key Features

• Delphi TC2281 suspension stabilizer bar link for front right placement
• Steel construction with steel housing for durable service
• Ball joint ends on both sides for suspension articulation
• Dust boot included to help protect the joint area
• Black rubber bushing material with POM bearing material
• Standard replacement grade for OE-style service
• Locking nuts included; M10 x 1.25 bolt thread size

Detailed Product Overview

Delphi applies OE engineering knowledge to its aftermarket steering and suspension portfolio, and the TC2281 follows that approach with dimensional and material analysis focused on fit and function. This front right stabilizer bar link measures 90 mm in length, 55 mm in width, and 60 mm in height, with a steel body and ball joint ends that support controlled suspension movement. It is a practical replacement for Nissan Maxima, INFINITI I30, and INFINITI I35 models where worn link hardware can affect handling feel and front suspension response. This part cross-references MOOG Chassis Products K90431 for the same application.

Common Problems This Part Can Help Address

• Front-end clunking or rattling from a worn stabilizer bar link
• Excessive play in the front suspension connection point
• Reduced stability during cornering and lane changes
• Uneven sway bar response caused by joint wear
• Noise from deteriorated dust boot or joint components

Installation Notes and Tips

Install this link at the front right position only. Verify bolt thread size, mounting points, and suspension orientation before installation on 2000-2003 Nissan Maxima, 2000-2001 INFINITI I30, or 2002-2004 INFINITI I35 models. Inspect the adjacent sway bar, strut, and mounting hardware for wear before completing the repair. Because this is a standard replacement stabilizer bar link, proper torque and alignment checks after installation help confirm correct suspension operation.

Quality Assurance

Delphi tests its OE-based steering and suspension parts under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure plus extended salt-spray testing. That validation supports consistent material performance and fit accuracy for the Delphi TC2281.