Delphi TC2302 Suspension Control Arm - Front Right Upper

OE-Style Front Right Upper Control Arm

Delphi TC2302 is a front right upper suspension control arm built for direct replacement service on select GM and Saab applications. It uses pressed steel construction with rubber and steel bushings to restore suspension geometry and steering response on vehicles such as the Chevrolet Trailblazer, GMC Envoy, and Saab 9-7x.

Key Features

• Pressed steel control arm for standard replacement service
• Bushings included for a complete arm assembly
• Rubber and steel bushing material for OE-style isolation and support
• No ball joint included
• Non-adjustable design for direct-fit installation
• Front right upper position
• Delphi part number TC2302

Detailed Description

Delphi TC2302 is engineered as a front right upper suspension control arm for vehicles that require precise upper-arm location and stable front-end alignment. Delphi applies OE-level dimensional and material analysis to help ensure proper fitment and consistent replacement performance. The pressed steel arm and standard replacement grade make it a practical choice for restoring worn suspension components on the Chevrolet Trailblazer, GMC Envoy, and related platforms. This part cross-references 25786775 for the same application.

Vehicle Fitment

• Fits 2002-2009 Chevrolet Trailblazer, front right upper.
• Fits 2002-2006 Chevrolet Trailblazer EXT, front right upper.
• Fits 2003-2006 Chevrolet SSR, front right upper.
• Fits 2002-2009 GMC Envoy, front right upper.
• Fits 2002-2006 GMC Envoy XL, front right upper.
• Fits 2004-2005 GMC Envoy XUV, front right upper.
• Fits 2005-2009 Saab 9-7x, front right upper.
• Fits 2003-2008 Isuzu Ascender, front right upper.
• Fits 2004-2007 Buick Rainier, front right upper.
• Fits 2002-2004 Oldsmobile Bravada, front right upper.

Common Repair Uses

• Restores worn upper control arm bushings
• Addresses looseness or play in the front suspension
• Helps correct uneven tire wear caused by suspension wear
• Supports proper front-end alignment after component replacement
• Replaces a bent or corroded upper control arm on GM and Saab platforms

Installation Notes

Verify the front right upper position before installation and compare the original arm to the replacement for mounting points and orientation. Because the ball joint is not included, confirm whether the existing joint is serviceable or whether additional parts are needed for the repair. After installation, perform a professional wheel alignment to set suspension geometry correctly.

Quality Assurance

Delphi tests steering and suspension components under extreme temperature and corrosion conditions, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. The brand’s OE-focused engineering and material validation support consistent fit and replacement quality for Delphi TC2302.